648966
18
Zoom out
Zoom in
Previous page
1/24
Next page
18 Waking up the transmitter and the receiver
5. Aim the source device’s remote control at the receiver and press buttons to see if the device
could be controlled. If not, the IR blaster frequency needs to be set and synced again. Follow
Step 4 and 5 until the source device’s remote control could work.
Waking up the transmitter and the receiver
• If in standby mode (both power indicators of the transmitter and the receiver are lit in red), press
the power button of either the transmitter or the receiver to turn on both the transmitter and the
receiver. The same condition applies to remote control operation.
• If the transmitter’s HDMI out display is on (transmitter’s power indicator is lit in blue) and the
receiver stays in standby mode (receiver’s power indicator is lit in red), press the power button of
either the receiver or the transmitter to wake up the other and make wireless connection
automatically between each other.
The IR sensor supports remote’s signal protocol of NEC, RC5, and RC6 between 36 KHz ~ 56 KHz. Therefore, it
is possible that some devices may not be supported.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BenQ WDP02 - Wireless FHD Kit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BenQ WDP02 - Wireless FHD Kit in the language / languages: English as an attachment in your email.

The manual is 3,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BenQ WDP02 - Wireless FHD Kit

BenQ WDP02 - Wireless FHD Kit User Manual - German - 24 pages

BenQ WDP02 - Wireless FHD Kit User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info