648966
17
Zoom out
Zoom in
Previous page
1/24
Next page
17 Installation
4. Press SOURCE button on the remote control or on the top of the receiver/the transmitter for
source input switching until you see the video being transmitted.
Performing IR sync
The default IR blaster frequency setting is 47KHz, which is compatible with most remote controls.
With the connected IR blaster cable, it relays infrared commands from your remote control to the
connected source devices. After all the devices have been installed and powered on, you should be
able to control your source devices by pointing their remote control to the receiver. If one of your
source devices does not respond, follow the procedures to perform IR sync to set the IR frequency.
1. Place two AAA batteries into the remote control of the receiver/transmitter.
2. Make sure that the IR blaster cable has been connected with source devices and transmitter. See
Setting up the transmitter (Tx) on page 10 for details.
3. Make sure that the transmitter, receiver, and all the connected devices have been properly
connected and powered on, and the desired source has been transmitted. See Powering up all
devices and making source selection on page 16 for details.
4. Press the
IR button on the receiver’s remote control. The current IR frequency is displayed.
Press the
IR button again to set to a different IR frequency. See Change IR blaster frequency on
page 19.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BenQ WDP02 - Wireless FHD Kit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BenQ WDP02 - Wireless FHD Kit in the language / languages: English as an attachment in your email.

The manual is 3,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BenQ WDP02 - Wireless FHD Kit

BenQ WDP02 - Wireless FHD Kit User Manual - German - 24 pages

BenQ WDP02 - Wireless FHD Kit User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info