676002
28
Zoom out
Zoom in
Previous page
1/76
Next page
English
28
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 2 front adjuster feet. These adjusters change the image height and
projection angle.
To adjust the projector:
1. Adjust the foot before turning the projector to ensure that
the image is at the position you prefer.
2. To retract the foot, screw the front and rear adjuster feet in a
reverse direction.
If the projector is not placed on a at surface or the screen and
the projector are not perpendicular to each other, the projected
image becomes trapezoidal. To correct this situation, see
“Correcting 2D keystone” on page 29 for details.
y Do not look into the lens while the lamp is on. The strong light from the lamp may
cause damage to your eyes.
y Be careful when you press the adjuster button as it is close to the exhaust vent
where hot air comes from.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector
or remote control.
Within 3 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the values of Frequency
and Clock to provide the best picture quality.
The current source information will be displayed in the upper left corner of the screen for 3 seconds.
y The screen will be blank while Auto is functioning.
y This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
1. Adjust the projected image to the size that
you need using the zoom ring.
2. Then sharpen the image by rotating the focus
ring.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BenQ LH770 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BenQ LH770 in the language / languages: English as an attachment in your email.

The manual is 14,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info