810831
62
Zoom out
Zoom in
Previous page
1/72
Next page
EN
53
Category 3 *
Components allowed to be changed according to the bike or
bike part’s manufacturer
Pedal crank arm
(Provided that the distances/chainsets/frame
centre (Q-Factor) are observed)
Wheel without hub motor
(Provided that the ETRTO is observed)
Chain or drive belt
(Provided that the original width is observed)
Rim tape
(Use the correct rim tapes for the rims) Modi-
ed combinations may result in rim tape shift-
ing and thus in defective inner tubes)
Tyres
(The increased acceleration, additional weight
and more dynamic cornering require the use
of tyres approved for e-bike use. As a result,
compliance with the ETRTO is essential)
Brake hoses/brake cables
Brake pads
(Disc, roller, drum brakes)
Handlebar/stem unit
(Provided that there is no need to change the
lengths of cables and/or hoses. It should be
possible to change the seating position with-
in the original hose lengths for the benet of
the consumer. Going beyond that results in a
signicantly changed load distribution on the
wheel and could seriously affect steering)
Saddle and seat post unit
(Provided that the offset to the rear does not
exceed 20 mm with regard to the series/orig-
inal area of application. In this case as well,
modifying the load distribution beyond the in-
tended adjustment range could seriously affect
steering.
The length of the saddle brace on the saddle
frame as well as the saddle shape are also im-
portant)
Bicycle lights
(Headlights are designed for a specic voltage
which must be compatible with the vehicle’s re-
chargeable batteries. In addition, electromagnet-
ic compatibility (EMC) must be ensured provided
that the headlight may be responsible for a part
of the potential interference)
Sprockets and derailleur cassettes
*The manufacturer of the part can only approve a component
if it was tested in accordance with its intended use and with
standards beforehand. A risk analysis must also have been
performed.
Category 4
Components not requiring any special kind of approval to be
changed
Headset bearings
Bottom bracket
Pedals
(Provided that the pedal is not wider than the
series/original area of application)
Derailleur
Rear derailleur
(All gear change parts must be suitable for the
number of gears and be compatible with one
another)
Gear lever/grip shifter
Gear cables and housings
Chain rings/belt pulleys/sprockets
(Provided that the number of teeth and the di-
ameter is identical to the series/original area of
application)
Chain guard
Mudguards
(Provided that the width is not smaller than the
series/original parts and the distance to the
tyre is at least 10 mm)
Spokes
Inner tube of the same type with the same
valve
Dynamo
Rear light
Reector
Spoke reectors
Bike stand
Grips with screw clamps
Bell
Category 5
Special notes for mounting accessories
Bar ends are permitted
provided that they are mounted on the front
(The load distribution must not be signicantly
changed)
Rear view mirrors are allowed.
Additional battery/rechargeable battery-op-
erated headlights are permitted in accord-
ance with § 67 StVZO (Germany’s Road
Trafc Licensing Regulations).
Trailers are only permitted after approval
by the vehicle manufacturer.
Child seats are only permitted after approv-
al by the vehicle manufacturer.
Front baskets are not recommended due to
the undened load distribution. Only per-
mitted after approval by the vehicle man-
ufacturer.
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benno Pedelec - E-bike at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benno Pedelec - E-bike in the language / languages: English as an attachment in your email.

The manual is 3.33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Benno Pedelec - E-bike

Benno Pedelec - E-bike User Manual - Dutch - 74 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info