577368
14
Zoom out
Zoom in
Previous page
1/58
Next page
08/ 2012 14 / 58
BENNING ST 750 A
Pressthe<▼>buttontoopenthe"calendarview"toselectthemonthandtheyeardirectly.Select
themonthfromthelistandchoosethecorrespondingyearbymeansofthearrowbuttons(<◄>,
<►>).Tosetthetime,select"HH":"MM":"SS"respectivelyandsetthevaluebymeansofthe
arrowbuttons(<◄>,<►>).
7.7 Calibration / System Calibration
Probe calibration (compensation of the test cable): Depending on the test cable used, the probe
should be calibrated again. This calibration is necessary, because the resistance of the test ca-
ble will be taken into consideration for the measuring result of the protective conductor resistance
measurement! The calibration data will be saved permanently in the device.
Gotothe"Setup Selection"menuandpress<Calibration>.
Connecttheconnectingcable(testcable)totheyellow"Sonde/Probe"jackandtothegreen"Kal./
Cal."jack.Press<Probe Calibration>andconrmthemessagewith<Yes>. Now, probe calibra-
tion has been done successfully.
A ZERO balance / calibration is necessary, if in standstill or with a missing signal the displayed
measured values are not approximately at 0 (e.g. 0.000 mA). For this, go to the start menu and
press <Setup>, <Calibration>. Then, press <ZERO Balance> and start it by pressing <Yes>.
During calibration, no connecting cables of the test sample or other cables must be connected to
the device!
The device shall be calibrated at the manufacturer's in certain time intervals (see chap-
ter23"Maintenance/Calibration").
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benning ST 750A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benning ST 750A in the language / languages: English as an attachment in your email.

The manual is 7,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Benning ST 750A

Benning ST 750A User Manual - German - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info