- 7 -
Furthermore, according to the spatial disposition in the boiler room you can select three
mounting positions of feeding from the bunker towards feeding in the boiler: side design (See
Fig. No. 3), front design (See Fig. no. 4) and rear design (See Fig. No. 5).
The primary combustion air fan is placed on the side of the boiler upstream the feeder and is
connected to the stirrer. The amount of combustion air (primary and secondary) is regulated by
the control unit of the boiler.
The inlet and outlet of the heating water for connection to the heating system is located on the
outer side wall of the boiler and consists of two fittings with G 2 thread. The outlet fittings with
G 3/4" threads on the same wall of the boiler are used for installation of the drainage valves:
one for the combustion chamber, on for the tubular heat exchanger. At the rear of the boiler on
the top, there is a flue gas exhaust adapter leading to the chimney.
The flue gas exhaust increases the chimney draft (especially in the cold state and ignition) and
is an integral part of the boiler equipment.
Boiler body, its lid and doors are insulated with non-toxic insulation which reduces losses by
dissipating heat to the surroundings.
Steel casing is provided with quality powder paint colour finish.
