693644
31
Zoom out
Zoom in
Previous page
1/41
Next page
6. Over the burner a heat-resistant ceramic reflector is installed. There is
no special care demanded; only the ash appears at the surface of the
reflector. The ash can be removed, but the function of the device is not
influenced.
7. The engine is protected against the damage with thermo contact which
ensures the protection against burn off especially in the case when the
feed device is blocked. (regular temperature of the engine can reach
85°C). In case of overheating (if the critical temperature was exceeded)
the thermo contact shuts down the engine and the ventilator. Then you
must switch off the boiler, clear the fuel from the container through the
discharging gap and eliminate the fault. WARNING: before any
handling with the boiler check if the boiler is disconnected from
the electrical power (the plug is pulled out of the socket).
8. As there can appear a slight overpressure in the burner area due to the
function of a ventilator, keep in mind that the boiler must be tightly
closed (fire door, upper cover, cleaning gap of the feeder, container
cover etc.).
9. If the boiler is equipped with the fire extinguisher with paraffin
plug, make a visual check of the emergency extinguishing system from
time to time and refill water if necessary.
10. If the boiler is equipped with the fire extinguishing system with the
thermostatic valve and pressure bottle and If an emergency
condition (power cut for longer time) appears and the fuel burns up to
the fuel container, due to the higher temperature at the bottom of the
fuel container the thermostatic valve is opened and the space is filled
with water form the water supply system or from the installed water
pressure tank (see chapter 7.1.).
If the water pressure tank is a part of the emergency extinguishing
system the air pressure in the tank must be checked at lest once a year.
Remove the cap of the valve at the tank and with use of a common
manometer check the pressure. If the pressure is not sufficient, regulate
the pressure with an air pump or compressor to 0,5 bars.
11. The worm feeder drive gear and the turniket drive gear are filled with
synthetic oil from the production, that’s why the further maintaining is
not required.
10. Troubleshooting
If problems with operation of the boiler appear try to follow one of the following
solutions:
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benekov R51 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benekov R51 in the language / languages: English as an attachment in your email.

The manual is 1,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info