693644
26
Zoom out
Zoom in
Previous page
1/41
Next page
2. If the boiler is equipped with fire extinguishing device with thermostatic valve and
pressure tank, put into operation the the pressure botle of the emergency
extinguishing system. Proceed as follows:
a) remove the black plastic cap from the valve on the bottom of the pressure
bottle
b) by means of a compressor or an air pump, pressurize the pressure bottle
to 0,5 bar
c) screw the black plastic cap back onto the valve on the bottom of the
pressure bottle
d) connect the fire extinguishing system to the water supply system
3. Heat up in the boiler.
4. Bring the boiler to the working temperature. The recommended working
temperature of the output water is 65–80°C.
5. Check again the tightness of the boiler.
6. Carry out the stoking test according to the appropriate norms (see Certificate of
warranty)
7. Inform the user about the boiler attendance - see chapter 7.
8. Make a record in the Certificate of warranty.
7. Attendance by the user
7.1 Heating up in the boiler
1. Check the quantity of water in the heating system.
2. Check if the stop valves between the boiler and the heating system are
opened.
3. Check if the water circulating pump is working.
4. Clean the burner and the ashtray.
5. Fill the container with the specified fuel - see chapter 3. After the refilling close
the container carefully to prevent the intake of the false air in the burner
through the feed worm.
6. Connect the boiler to the electrical power network (230V/50Hz) with a cable
and a plug.
7. If the boiler is equipped with the automatic ignition, don’t take further
steps as the Instruction Control Unit analyses the state of the boiler and take
further steps as heating up etc. (see the separate Instruction Control Unit
users manual). During the heating up and the running of the boiler the fire door
must be closed.
8. If the boiler is not equipped with the automatic ignition, it is necessary to
heat the boiler up manually (see the separate Instruction Control Unit users’
manual). Use the manual mode at the Instruction Control Unit to transport the
fuel to the combusting area. Let the worm feeder switched on until the fuel
appears in the burner (approx. 1 cm under the grate rim). Further on switch off
the worm feeder, place some kindling (paper, dry wood chips, solid alcohol or
some other fire lighter recommended for these purposes) on the top of the
fuel, set the fire and wait until the fire begins to burn (1-2 min.) Then add a
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benekov R51 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benekov R51 in the language / languages: English as an attachment in your email.

The manual is 1,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info