582398
33
Zoom out
Zoom in
Previous page
1/52
Next page
33
EN
Mounting over a washing machine
A fixing device should be used between
the two machines when installing the dryer
above a washing machine. The fixing device
(2977200100 white/2977200400 grey) must
be installed by the Authorized Service Agent.
Total weight of the washing machine and the
dryer -with full load- when they are placed
on top of each other reaches to approx. 180
kilograms. Place the products on a solid floor
that has sufficient load carrying capacity!
Connecting to the drain
In products equipped with condenser unit, water
accumulates in the water tank during the drying
cycle. You should drain accumulated water after
each drying cycle.
You can directly drain accumulated water through
the water drain hose supplied with the product
instead of periodically draining the water collected
in the water tank.
Connecting the water drain hose
1. Pull hose in the product by hand in order to
disconnect it from where it is connected. Do
not use any tools to remove the hose.
2. Connect one end of the drain hose supplied
separately with the product to the connection
point from where you removed the hose of
the product in previous step.
3. Connect the other end of the drain hose
directly to the wastewater drain or to the
washbasin.
A
Hose must be fixed in every type of
connection. Your house will be flooded if the
hose comes loose during water discharge.
C
Water drain hose should be attached to a
height of maximum 80 cm.
C
Make sure that the water drain hose is not
stepped on and it is not folded between the
drain and the machine.
Adjusting the feet
In order to ensure that the product operates more
silently and vibration-free, it must stand level and
balanced on its feet. Balance the machine by
adjusting the feet.
Turn the feet to left or right until the machine
stands level and firmly.
C
Never remove the adjustable feet from their
housings.
Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the values in
the "Technical specifications" table. Our company
shall not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
Connection must comply with national
regulations.
Power cable plug must be within easy reach
after installation.
The voltage and allowed fuse or breaker
protection are specified in the “Technical
specifications” section. If the current value of
the fuse or breaker in the house is less than
10 Amps, have a qualified electrician install a
10 Amp fuse.
The specified voltage must be equal to your
mains voltage.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO DPU 8305 XEL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO DPU 8305 XEL in the language / languages: English, German as an attachment in your email.

The manual is 5,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info