475979
45
Zoom out
Zoom in
Previous page
1/60
Next page
Note 1:
Your TV will go to stand-by mode in five
mimutes if there is no broadcast signal
Note 2:
YourTV is equiped to oparate with TV
buttons in case your R/C is broken or the batteriesare
exhauseted.
3. Press the Main power on/off button
located on the LCD TV..
4. To power on your television, press
any numerical key on the remote control
or the key “
“/” “.
For this process, you can also use the
TV. buttons found on the panel of your
television. The picture will be visualized
on the screen after a while.
Note: If you are not going to use your television
for a long period of time, make sure to switch it
off from the power on/off button.
Initial power on and settings performance
To set up your television, read the parts on the
TV controls and performance of the broadcast
settings.
Batteries
Open the lid of the battery compartment and
make sure you have placed the batteries in the
correct direction.
For this remote control, the battery types UM-4,
IEC R03 or AAA 1.5 V are suitable.
Do not throw your old batteries into the fire,
discard then in the waste areas dedicated to this
purpose.
Do not use the used, old batteries with new ones
and different types of batteries together.
The performance of the remote control will be
reduced at a distance of 8 meters from or at an
angle of 30 degrees beyond the centre of the
TV.
Start
Remove your television carefully out of its box.
You can keep the package of your television to
use it later on.
Contents of the box
Power cable
Remote Control
2 batteries
Note: The Scart, , HDMI, VGA and RCA cables
are not supplied with the device.
Antenna connection
If you use a coaxial cable (round cable) of 75
Ohms as an antenna cable, connect the antenna
plug directly to the antenna input located on the
TV.
The motorized vehicles, energy and
telecommunication lines affect your antenna.
Therefore, be careful about installing your
antenna away from these and metal surface in
such a way that it shall not swing.
Do not have your antenna cable longer than
required and do not shape it in a roll. Make sure
that it is not cramped while passing through a
window or door.
Your antenna and cable might be affected by
natural phenomena such as rain, wind, smoke
and humidity over time. Check periodically your
antenna and equipment.
Powering on your set and the
initial use
1. Insert the power cable plug supplied with the
device into the socket.
2. Insert the power cable into the power supply
input located on the back panel of the LCD TV.
7
-6-
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO 40 LMLCDC33 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO 40 LMLCDC33 in the language / languages: Dutch as an attachment in your email.

The manual is 1,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info