810611

Beefeater Signature 3000 series Manual

8
Zoom out
Zoom in
Previous page
1/20
Next page
8
Mobile Installation - Portable LPG
Recommended minimum LPG cylinder capacity for use with this appliance is 4kg. Maximum portable LPG
cylinder capacity for use with this appliance is 15kg. Ensure the cylinder valve and barbecue control knobs
are all off. Remove the protective cap from the cylinder if present.
Fit only the correct regulator and hose for your country gas category and operating pressure to your cylinder.
Your barbecue may either be supplied with a regulator and hose to suit your
country gas category and pressure, or with a brass inlet adaptor to which you
will have to attach a regulator and hose supplied by your local gas supplier. The
hose must not exceed 1.50m in length.
Following the instructions that came with your regulator, connect the hose and
regulator to the gas inlet adaptor supplied. This adaptor is then fitted to the inlet
of the barbecue, located on the right hand side of the unit. Ensure the hose
does not twist or kink.
Secure all joints spanner (wrench) tight but do not over-tighten. Proceed to leak
test.
Connection to Barbecue & Gas Supply
Before You Begin
If you have not done so already, check the gas type label as described earlier.
This appliance must not be installed under or on any combustible material. Minimum clearance from
combustible materials to all sides of the appliance is 450mm.
The appliance must be tested for safe and proper operation on completion of installation.
The flexible PVC hose assembly supplied must not be exposed to temperatures in excess of 60°C. DO NOT
expose to the sun’s direct heat and DO NOT allow the hose to come in contact with the hot surface of the
barbecue body.
This barbecue is not approved for use on recreational vehicles or marine craft.
Check with your local gas supplier to ensure that your barbecue gas category, and information on the
appliance data plate is correct for the gas supply in your country. You will find the gas type label on the side of
your barbecue. You should also refer to the technical information on the back of this manual. If your barbecue
is of the incorrect gas type or pressure, or if you are unsure, consult your dealer before going any further.
Fixed Installation - Portable LP Gas/Propane.
Connect the gas supply line to the barbecue inlet located on the right side of the appliance using either hard
plumbing, or a flexible hose connected to a bayonet point. Refer to your local installation code for pipe sizing
details. Secure all joints spanner tight but do not over-tighten. Proceed to leak test.
Test gas pressure by removing the last burner from the left hand side of the barbecue and attaching a hose
and pressure gauge to the end of the gas valve. Turn on 2 burners and check the pressure.
For mobile trolley installations that use flexible hosing to connect to a static propane supply, a chain or similar
restraining device must be fitted to prevent strain on the gas supply line. One end of the chain should attach
to the barbecue; the other end should attach to a fixed structural point close to where the hose connects to
the gas piping. The chain must be at least 30% shorter than the gas supply line. In this way, if the barbecue
is accidentally moved, the chain stops the barbecue from stretching the hose.
Typical regulator
connection
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beefeater Signature 3000 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beefeater Signature 3000 series in the language / languages: English as an attachment in your email.

The manual is 2.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info