Manual Baumatic segreto (page 17 of 19) (English)

129297

Zoom out

Zoom in

1/19

Touched once more, the suction motor switches off (Stand-

by).

Need to wash the anti-fat filter: GREEN led FLASHING

(read the instructions relative to “Reset and configuration of

the filters saturation signal")

Need to wash or replace the carbon filters: ORANGE

(amber) led FLASHING (read the instructions relative to

“Reset and configuration of the filters saturation signal”)

Note: reset can be carried out both with the control lever and

the remote control.

Control of the central light

The central light can be switched on and off by touching the

LOWER PART of the control bar BRIEFLY.

Control of the lateral lights (when envisaged)

The lateral lights can be switched on and off by touching IN A

PROLONGED MANNER the LOWER PART of the control

lever.

The PROLONGED TOUCH allows, other than switching on

and off, adjusting the intensity of the light emitted by the lamp.

Note: The functions of switching and off (and adjustment)

alternate.

The light intensity regulation feature is not available for hoods

with neon lights.

Reset and configuration of the filters saturation signal

Switch the hood on at any speed (see paragraph above

“Selection of the suction speed (power)”

Reset anti-fat filter saturation signal (GREEN LED

FLASHING on the control level)

First proceed with the maintenance of the filter as

described in the corresponding paragraph.

Touch in a prolonged manner (more than 3 seconds) the

UPPER PART of the control lever, the LED stops flashing to

indicate that the reset of the signal has been carried out and

the hood switches off.

Reset anti-fat filter saturation signal ORANGE (amber)

LED FLASHING

First proceed with the maintenance of the filter as

described in the corresponding paragraph.

Touch in a prolonged manner (more than 3 seconds) the

UPPER PART of the control lever, the LED stops flashing to

indicate that the reset of the signal has been carried out and

the hood switches off.

Deactivating the carbon filter saturation signal (for

special applications)

Switch the hood off (see paragraph above “Select the suction

speed power”)

Touch in a prolonged manner (more than 5 seconds) the

UPPER PART of the control lever, the LED flashes in GREEN

(amber) to indicate that the carbon filter saturation signal has

been deactivated.

To reactivate the carbon filter saturation signal, repeat the

operation. The LED flashes in ORANGE.

Maintenance

Before performing any maintenance operation, isolate the

hood from the electrical supply by switching off at the

connector and removing the connector fuse.

Cleaning

The cooker hood should be cleaned regularly (at least with the

same frequency with which you carry out maintenance of the

fat filters) internally and externally. Clean using the cloth

dampened with neutral liquid detergent. Do not use abrasive

products.

DO NOT USE ALCOHOL!

Grease filter

Fig. 25

This must be cleaned once a month (or when the filter

saturation indication system – if envisaged on the model in

possession – indicates this necessity) using non aggressive

detergents, either by hand or in the dishwasher, which must

be set to a low temperature and a short cycle.

When washed in a dishwasher, the grease filter may discolour

slightly, but this does not affect its filtering capacity.

Charcoal filter (filter version only)

Fig. 25

It absorbs unpleasant odours caused by cooking.

The charcoal filter can be washed once every two months (or

when the filter saturation indication system – if envisaged on

the model in possession – indicates this necessity) using hot

water and a suitable detergent, or in a dishwasher at 65°C (if

the dishwasher is used, select the full cycle function and leave

dishes out).

Eliminate excess water without damaging the filter, then put it

in the oven for 10 minutes at 100° C to dry completely.

Replace the mattress every 3 years and when the cloth is

damaged.

Replacing lamps

Fig. 1-5

Disconnect the hood from the electricity.

Warning! Prior to touching the light bulbs ensure they are

cooled down.

To replace the central lamp: use only 40W max 40° D25

GU10.halogen lamps.

Removing the bulb:

rotate anti-clockwise a quarter turn and take out.

Mounting the bulb:

insert the bulb in its seat so that its contacts enter the

congruent seats on the bulb-holder, rotate clockwise for about

a quarter turn.

Some models envisage lateral lamps:

Replace them with identical forms of 40W (E14) max).

Remove cover A to access the lamp housing A.

If the lights do not work, make sure that the lamps are fitted

properly into their housings before you call for technical

assistance.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Baumatic segreto in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Baumatic segreto Manual

Product: