793825
12
Zoom out
Zoom in
Previous page
1/16
Next page
12
CLEANING
Never use steam cleaning equipment.
Do not use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these
could damage the surfaces of the appliance.
Clean the vacuum packing machine with a soft cloth or sponge and neutral detergent.
In order to ensure hygiene and safeguard the quality of foodstuffs packed, the vacuum
chamber and glass lid must be cleaned after each use.
Use a soft cloth or non-abrasive sponge and neutral detergent.
Once a month, clean the sealing bar in order to remove any residue which could negatively
impact the quality of bag sealing.
To facilitate this procedure, lift the sealing bar (A) up, removing it from the two pins (B). Use a
soft cloth or non-abrasive sponge and neutral detergent.
After cleaning, fit the bar on the pins (B), lining up the two holes on the underside of the bar
and make sure it engages securely without removing the black teflon pipe.
If you plan not to use the machine for a prolonged period of time, clean it thoroughly.
Before using again, unplug and clean it thoroughly again and restart.
Automatic dehumidification cycle
It is advisable to perform a dehumidifcation cycle, once a week for intensive usage, by close
the lid of the vacuum chamber as normal and keeping it down, press the button for the
Vacuum bag cycle for 5 seconds; this cycle will lasts about 20 minutes.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
All the led indicators on
the control panel flash. Overheating.
Switch the machine off and wait
for approximately 15 minutes to
allow cooling and automatic reset
of the thermal overload cutouts.
If the problem persists when the
machine is switched back on
again, call the after sales service.
The led indicator of the
STOP button flashes,
accompanied by an
intermittent acoustic
signal
Insufficient vacuum in the
chamber.
• Lid not pressed at start of cycle.
• Lid of vacuum container not
properly fitted.
• Lid seal worn or incorrectly
positioned.
• Switch the machine off and wait
for approximately 15 minutes.
If the problem persists when the
machine is switched back on
again, call the after sales service.
Upon switching on, all
the led indicators on the
control panel flash for
3 seconds and a long
acoustic signal is emitted.
Pump oil replacement reminder. Call the Bauknecht after sales
service.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht SVD11 F140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht SVD11 F140 in the language / languages: English as an attachment in your email.

The manual is 2.73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht SVD11 F140

Bauknecht SVD11 F140 User Manual - German - 16 pages

Bauknecht SVD11 F140 User Manual - Dutch - 16 pages

Bauknecht SVD11 F140 User Manual - French - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info