572381
19
Zoom out
Zoom in
Previous page
1/26
Next page
5019 496 01079
1
GB
GSI 7990
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison test and
other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on Standard NF EN 13697 - November 2001.
1. OVERVIEW
Programme selector
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected programme
and options are cancelled. Main failure displays (repeated flashing
of the START indicator lamp) can be cancelled by RESETTING.
Detailed instructions are given in chapter 5 “What to do if...”.
Power Clean
High pressure with an additional jet for better washing results and
greater bottom rack load flexibility.
When this option is selected, the display shows the corresponding
symbol.
Detergent setting upon initial use and when using a different type of detergent
1. Select the third programme in the relative table.
2. Press the START button for approx. 7 sec. to change the display.
3. Using the START button, select the desired detergent:
Display shows: no symbol = powder detergent (factory setting)
(rinse aid and/or salt indicator on)
= 2 in 1
= 3 in 1 or other combined action detergents
(In this way, the rinse aid and/or salt indicator is deactivated)
4. Switch the appliance off and then switch it on again. The type of detergent
selected will be shown on the display.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (hh).
If “F..” appears on the display, see chapter 5 “What to do if...”.
Delayed Start button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
Programme sequence indicator
Rinse aid level indicator and salt level indicator
These indicator lamps light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Half Load/Multizone button
Load the upper or lower rack only.
Press once = wash upper rack (the indicator/symbol lights up)
Press twice = wash lower rack (the indicator/symbol lights up)
Press 3 times = Off (Half load/Multizone deactivated).
When washing without the upper rack, press the “Half load” (i.e.
“wash lower rack”) button twice, (the corresponding indicator/
symbol lights up).
On / Off button
Prewash Washing Drying
Table 1.1.
Programme chart
Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Loading instructions
large small Litres kWh Minutes
1
40-70°C
Normally or heavily soiled crockery, including pots
and pans.
X X 7-17 0.99-1.75 65-220 ±
1)
2
Pre-Rinse cold
Crockery to be washed later.
4.0 0.03 14 ±
1)
3
Glasses 40°C
Lightly soiled, e.g. glasses and cups, with a lower
pressure jet.
X 10.0 0.85 100 ±
1)
4
Quickwash 40°C
Lightly soiled crockery, with no dried-on food.
X 10.0 0.65 30 ±
1)
5
Bio
2)
50°C
Normally soiled crockery. Energy-saving
programme.
X X 11.0 1.05 170 ±
1)
6
Hygienic +
3)
Normally or heavily soiled crockery, with
additional antibacterial wash. Programme
interruption (e.g. due to door opening) can
compromise elimination of germs.
X X 13.0 1.50 115 ±
1)
7
Overnight 55°C
Normally soiled crockery, gentle and quiet (39
dbA) thanks to the lower pressure jet.
X X 13.0 1.20 290 ±
1)
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht GSI 7990 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht GSI 7990 in the language / languages: English as an attachment in your email.

The manual is 1,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht GSI 7990

Bauknecht GSI 7990 User Manual - German - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info