723420
7
Zoom out
Zoom in
Previous page
1/8
Next page
EN
7
EXTERIOR SURFACES
. Clean surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
. Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
. After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
oven to cool completely and then wipe it with a cloth
or sponge.
. If there is stubborn dirt on the interior surfaces, we
recommend running the automatic cleaning function
for optimal cleaning results.
. Clean the glass in the door with a suitable liquid
detergent.
. The door can be easily removed and refitted to
facilitate cleaning of the glass WWW .
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
Do not use steam cleaning
equipment.
Use protective gloves during all
operations.
Carry out the required
operations with the oven cold.
Disconnect the appliance from
the power supply.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
REMOVING AND REFITTING THE DOOR
1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
2. Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b).
~60°
a
b
~15°
Put the door to one side, resting it on a soft surface.
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4. Lower the door and then open it fully.
Lower the catches into their original position: Make
sure that you lower them down completely.
5. Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above.
CLICK TO CLEAN  CLEANING THE GLASS
1. After removing the door and resting it on a soft
surface with the handle downwards, simultaneously
press the two retaining clips and remove the upper
edge of the door by pulling it towards you.
2. Firmly hold the panes of glass with both hands,
remove them and place them on a soft surface before
cleaning.
3. Ret the intermediate pane (marked with “1R”)
before retting the inside pane: To position the panes
of glass correctly, make sure that the “R” mark can be
seen in the left-hand corner. First insert the long side
of the glass marked “Rinto the support seats, then
lower it into position. Repeat this procedure for both
panes of glass.
4. Refit the upper edge: a click will indicate correct
positioning. Make sure the seal is secure before
refitting the door.
MAINTENANCE
AND CLEANING
Download the Use and Care Guide from
docs.bauknecht.eu for more information
WWW
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht BAK3 KP8V IN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht BAK3 KP8V IN in the language / languages: English as an attachment in your email.

The manual is 8,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht BAK3 KP8V IN

Bauknecht BAK3 KP8V IN User Manual - English, German - 36 pages

Bauknecht BAK3 KP8V IN User Manual - German - 8 pages

Bauknecht BAK3 KP8V IN User Manual - Dutch - 36 pages

Bauknecht BAK3 KP8V IN User Manual - Dutch - 8 pages

Bauknecht BAK3 KP8V IN User Manual - Danish, French - 36 pages

Bauknecht BAK3 KP8V IN User Manual - French - 8 pages

Bauknecht BAK3 KP8V IN User Manual - Italian, Spanish, Norwegian - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info