Manual Batavia BT-TS001 FLIPOUT (page 13 of 32) (English, German, Dutch, French)

589472

Zoom out

Zoom in

1/32

English

• Do not store in locations where the tem-

perature may exceed 40 °C.

• Charge only at ambient temperatures

between 10 °C and 40 °C.

• Charge only using the charger provided

with the appliance/tool.

• When disposing of batteries, follow the

instructions given in the section

"Disposal".

• Do not damage/deform the battery pack

either by puncture or impact, as this may

create a risk of injury and re.

• Do not charge damaged batteries.

• Take special care of the battery. Avoid

dropping it onto any hard surface and do

not subject it to pressure or any other form

of mechanical stress. Keep the battery

away from extreme heat and cold.

• Important Danger! Never short-circuit the

battery or expose it to moisture. Do not

store it together with any metal parts

which could short-circuit the contacts.

The battery could overheat, start burning

or explode.

Under extreme conditions, battery leakage

may occur. When you notice liquid on the

batteries, proceed as follows: Carefully wipe

the liquid off using a cloth. Avoid skin contact.

In case of skin or eye contact, follow the

instructions below.

Warning!

The battery uid may cause personal injury or

damage to property.

In case of skin contact, immediately rinse with

water. If redness, pain or irritation occurs seek

medical attention. In case of eye contact, rinse

immediately with clean water and seek medical

attention.

Chargers

Your charger has been designed for a specic

voltage. Always check that the mains voltage

corresponds to the voltage on the rating plate.

Warning!

• When not in use and before cleaning and

servicing, disconnect the battery charger

from the power supply.

• Never attempt to replace the charger unit

with a regular mains plug.

• Use your charger only to charge the bat-

tery in the appliance/tool with which it was

supplied. Other batteries could burst,

causing personal injury and damage.

• Never attempt to charge non-rechargeable

batteries.

• If the supply cord is damaged, it must be

replaced by the manufacturer or an

authorized Service Centre in order to avoid

a hazard.

• Do not expose the charger to water.

• Do not open the charger.

• Do not probe the charger.

• The appliance/tool/battery must be placed

in a well ventilated area when charging.

OPERATION

Operation of Lithium-Ion Batteries

Lithium-ion batteries share many characteris-

tics with conventional batteries.

The major difference is that Lithium-ion batter-

ies do not have a “memory” and do not require

to be completely discharged periodically. It is

recommended to charge Lithium-ion batteries

after each use so they will be fully charged

when needed.

Lithium-ion batteries perform best and deliver

peak output power at room temperature.

When operated in lower temperatures, the

battery output will be reduced.

NOTE: A fully charged battery will loose about

2% of its charge per month during storage.

ASSEMBLY AND OPERATION

Charging the Battery

1. Insert the charger plug into the receptacle

(4) in the side of the driver.

2. Plug the battery charger (10) into a 120 V,

60 Hz wall receptacle.

Notes:

a. Make sure the charger plug is fully

inserted into the matching receptacle at

the side of the driver handle.

b. A new battery or one that is completely

exhausted should be charged for one hour

or until the red charging indicator LED

turns OFF. After normal use, a battery

should be fully charged in one hour.

c. If the battery does not charge properly,

check to make sure the electrical outlet is

"live" and that the temperature range in the

work area is between 0–40° C.

7062267_FlipOut_Ma_#1503-12.indb 13 26-03-15 09:11

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Batavia BT-TS001 FLIPOUT in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,44 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Batavia BT-TS001 FLIPOUT Manual

Product: