> Using the tape recorder
20
Automatic tape reverse function
The display shows the current automatic tape
reverse setting – glowing steadily for ON; blinking
for OFF
The BeoSound Century tape recorder
always plays through the entire tape
(A and B side) before stopping.
This automatic tape reverse function
can of course be switched off during
recording so that your recording is
only made on one side of the tape at
the time.
Make the tape recorder ready for
recording
Press to see the current automatic
tape reverse setting
then
Press again to change from ON to
OFF, or vice versa
After pressing the REC button to start
recording, press the MODE button. A
tape reverse symbol appears in the
display to indicate the current setting –
glowing steadily for ON; blinking for
OFF.
Press MODE again to change from ON
to OFF, or vice versa.
Note: You may, of course, leave the automatic
tape reverse function ON so that your recording is
made on both sides of the tape you have loaded –
if required.
MODE
REC
MODE