658678
21
Zoom out
Zoom in
Previous page
1/26
Next page
|
21
Cleaning and maintenance | ZM Series User Manual
Cleaning and maintenance
If the display requires cleaning, use a damp soft cloth (e.g. microber) with a mild, non-
abrasive glass cleaner. Ensure cloth is regularly washed or replaced.
¼ Note: Do not use paper products as they may scratch the surface. To minimize the risk of
abrasion, allow the screen to air dry.
¼ Note: Never use acidic, ammonia based, or abrasive cleaning products to clean the display.
These products will damage special coatings on the glass.
¼ Note: To prevent damage caused by lightning strikes, it is recommended to disconnect the
display from the power source during intense storms, or when the product is not in use for
extended periods.
Display removal
The displays top and bottom bezel trim
must be removed in order to undo the
fasteners holding unit in place by the
mounting ange. The bezel trim have
been designed to be very low prole, and
therefore fully conceal the locking tabs
that keep them from being accidentally
disengaged from the mounting ange. To
release the locking tab, it is necessary to
gently lever the centre of the bezel trim
away from the mounting ange. To remove
the cover, simultaneously slide it sideways;
to the right for the top cover, and to the left
for the bottom cover.
The mounting brackets should be loosened
in reverse order to tting. To remove the
brackets, depress the locking tab before
sliding brackets upwards.
Replacing the gasket
The foam gasket on the rear of the display bezel is available as an optional accessory, should
the factory installed item be damaged.
Fit the two lengths of foam gasket in to the
rebated channel on the back of the displays
mounting ange. Only remove backing
paper from the side to be stuck to monitor,
and only remove a small amount at a time.
Ensure the gasket ends of the two halves
overlap and make contact.
¼ Note: take care not to stretch gasket when applying. Only pull gasket minimum amount
required to lay it on straight. The backing paper on outside of gasket will help prevent stretch,
and should only be removed when display is ready to install in to dashboard.
7
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BandG ZM16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BandG ZM16 in the language / languages: English as an attachment in your email.

The manual is 5,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BandG ZM16

BandG ZM16 User Manual - German - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info