658717

BandG WTP3 Manual

16
Zoom out
Zoom in
Previous page
1/102
Next page
14
Calibration
Controls the calibration of variables by allowing you to input a
calibration value to a particular variable , WTP3 has a sample set of
calibration data as follows
Bspd_port and Bspd_stbd
Boat speed calibrations for the port and starboard side sensor respectively in
knot. If you have only one boat speed sensor connected to both inputs enter
the same value in both port and starboard. If you do not know what these
values are, the boat speed can be calibrated using the cal boatspeed option.
Heading_1
Heading oset value for compass1. Once you have run the calibration routines
for the compass sensor), you still need to align the unit relative to the boat.
The most accurate way to do this is to sail on a known bearing towards a xed
charted object a long distance away. You then use Heading_1 to correct the
compass bearing on the instruments until it matches the known bearing of
the object. A positive oset will increase the reading of the compass heading.
Heel_1
Oset value for the rst heel sensor. If the heel angle does not read zero when the boat is sitting upright in the
water it is necessary to enter a correction value here. The heel sensor shows positive values when you are heeled
to port, as on starboard tack upwind.
Trim_1
Oset value for the rst trim sensor. If the trim angle does not read zero when the boat is sitting upright in the
water it is necessary to enter a correction value here. The trim sensor shows positive values when the bow is
trimmed down.
MHU_angle
Oset angle for the masthead unit sensor at the top of the mast. If you enter a positive value, it will decrease the
Apparent Wind Angle on starboard tack, and increase the Apparent Wind Angle on port tack.
Depth
Oset for adjusting the depth sensor reading from the transducer position to either the keel (negative values) or
the waterline (positive values).
Note: You can control which variables you are able to calibrate from this dialogue by adjusting the ‘svcals.d’ data le.
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BandG WTP3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BandG WTP3 in the language / languages: English as an attachment in your email.

The manual is 7,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info