661363
156
Zoom out
Zoom in
Previous page
1/184
Next page
PREPARING FOR BOBBIN WORK
E-90
l
Using scissors carefully trim the thread tail
as close to the bobbin as possible.
a Beginning of wound thread
m
Install the bobbin wound with thread.
Whether or not tension should be applied to the
bobbin thread depends on the type of thread being
used.
When tension is applied to the
bobbin thread
Insert bobbin into bobbin case so the thread
unwinds from the left side.
Then correctly pass the thread through the tension
spring as shown below.
a Tension spring
CAUTION
Use a bobbin thread that has been correctly
wound. Otherwise, the needle may break or
the thread tension will be incorrect.
The included bobbin was designed specifically
for this machine. If bobbins from other models
are used, the machine will not operate
correctly. Use only the included bobbin or
bobbins of the same type (part code:
X52800-150).
* Actual size
a This model
b Other models
c 11.5 mm (approx. 7/16 inch)
Note
Slowly and evenly wind the thread around
the bobbin.
For best results, wind the bobbin so the
thread is snug and not twisted.
CAUTION
If thread extends beyond the top of the bobbin
too much, the thread may become tangled or
the needle may break.
Memo
If inserting thread tail through bobbin hole is
difficult, bobbin can be wound by holding
the tail and wrapping thread around inside
base. Then carefully trim thread tail so it
does not extend from the side of the
bobbin.
CAUTION
When winding the bobbin, make sure the
thread is not frayed. Embroidering with frayed
thread may result in the thread catching on
the tension spring of the bobbin case, the
thread completely becoming tangled or
damage to the machine.
Do not guide the bobbin thread completely
through the groove in the needle plate cover,
otherwise the lower threading cannot be done
correctly. Thread only as far as shown below.
156


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Spirit - BLPY at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Spirit - BLPY in the language / languages: English as an attachment in your email.

The manual is 14,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Baby Lock Spirit - BLPY

Baby Lock Spirit - BLPY Additional guide - English - 1 pages

Baby Lock Spirit - BLPY Quick start guide - English, French, Spanish - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info