661219
34
Zoom out
Zoom in
Previous page
1/42
Next page
M
A
I
N
T
E
N
A
N
C
E
33
Replacing Needle
1. Press and hold the positioning button for approxi-
mately 2 seconds to set the machine to the loading
position. (Fig. A)
REMINDER: Remove fabric and cut thread before
putting machine into the loading position.
2. Lower the presser foot. (Fig. B)
3. To move the latch wire from in front of the needle
grasp the latch wire lever and pull straight down, turn
the lever 90 degrees towards you and release. Lever
will remain in the down position. (Fig. C)
4. While holding needle with tweezers loosen the nee-
dle clamp screw and remove needle. (Fig. D)
5. With the flat side of the new needle facing the right
side of needle clamp insert the needle into the open-
ing as far up as it will go. Securely tighten the nee-
dle clamp screw. (Fig. E)
6. Restore the latch wire to its original position. (Fig. F)
7. After restoring the latch wire, make sure the latch
wire is in the center channel of needle. (Fig. G)
A
B
C
D
E
F
G
Loading
Position
Positioning
Button
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Sashiko 2 - BLQK2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Sashiko 2 - BLQK2 in the language / languages: English as an attachment in your email.

The manual is 5,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info