661207
106
Zoom out
Zoom in
Previous page
1/128
Next page
Care and Maintenance
A-2
Restrictions on oiling
In order to prevent damaging this machine, it must not be
oiled by the user.
This machine was manufactured with the necessary amount
of oil applied to ensure correct operation, making periodic
oiling unnecessary.
If problems occur, such as difficulty turning the handwheel or
an unusual noise, immediately stop using the machine, and
contact your authorized Baby Lock retailer.
Precautions on storing the machine
Do not store the machine in any of the locations described
below, otherwise damage to the machine may result, for
example, rust caused by condensation.
Exposed to extremely high temperatures
Exposed to extremely low temperatures
Exposed to extreme temperature changes
Exposed to high humidity or steam
Near a flame, heater or air conditioner
Outdoors or exposed to direct sunlight
Exposed to extremely dusty or oily environments
Cleaning the LCD screen
If the screen is dirty, gently wipe it with a soft, dry cloth. Do
not use organic solvents or detergents.
Cleaning the machine surface
If the surface of the machine is dirty, lightly soak a cloth in
neutral detergent, squeeze it out firmly, and then wipe the
surface of the machine. After cleaning it once with a damp
cloth, wipe it again with a dry cloth.
Cleaning the race
Sewing performance will suffer if lint and dust collects in the
bobbin case, therefore, it should be cleaned regularly.
a
Press (Needle position button) to raise the needle.
b
Turn off the machine.
c
Unplug the power cord from the power supply jack on
the right side of the machine.
d
Raise the presser foot to remove the needle, presser
foot and presser foot holder.
For details, refer toReplacing the needle” and
“Replacing the Presser Foot” in the “Basic
operations” section.
e
Remove the flat bed attachment if it is attached.
Chapter 1
MAINTENANCE AND
TROUBLESHOOTING
Care and Maintenance
In order to extend the life of this machine,
periodically turn it on and use it.
Storing this machine for an extended period of
time without using it may reduce its efficiency.
Do not wipe the LCD screen with a damp cloth.
Occasionally, condensation may form on the LCD
screen or it may become fogged up; however, this
is not a malfunction. After a while, the cloudiness
will disappear.
CAUTION
Unplug the power cord before cleaning the
machine, otherwise injuries or an electric
shock may occur.
CAUTION
Unplug the power cord before cleaning the
machine, otherwise injuries or an electric
shock may occur.
106


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Presto BLMPR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Presto BLMPR in the language / languages: English as an attachment in your email.

The manual is 3,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Baby Lock Presto BLMPR

Baby Lock Presto BLMPR Quick start guide - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info