661214

Baby Lock Ovation - BLES8 Manual

13
Zoom out
Zoom in
Previous page
1/92
Next page
O
V
E
R
V
I
E
W
11
Thread Cutter
Presser Foot Pressure Adjustment
Snap-On Presser Foot
There is a thread cutter located on the left side of your Ovation.
At the end of a seam, sew off the fabric edge and continue sewing to
create a 5-6 inch (12.5-15cm) thread chain.
Bring the chain of thread up and from the back to front through the
thread cutter.
The presser foot pressure has been preset at the factory and rarely
needs adjustment. You may find it necessary, however, to decrease
the pressure for thick fabrics or increase pressure for thin fabrics to
feed more smoothly under the foot. Turn the adjusting dial on left side
of the machine.
To increase pressure, turn the pressure adjusting dial counterclock-
wise.
To decrease pressure, turn the dial clockwise.
The Ovation has the convenience of a snap-on presser foot
system.
To Release:
1. Raise the presser foot thread release lever to highest
position.
2. Lock the cutting blade down.
3. Raise the needles to their highest position.
4. Push the presser foot release lever located at the back of the
presser foot holder.
5. Slide presser foot slightly toward you and carefully turn the
back section of foot clockwise 90 degrees.
6. Slide the presser foot to the rear to remove.
To Replace:
1. Raise the presser foot thread release lever.
2. Lock the cutting blade down.
3. Raise the needles to the highest position.
4. Slide the foot from the left to right.
5. Align the bar of the foot with the groove in the holder.
6. Lower the presser foot thread release lever to snap into
place.
The presser foot that comes with the Ovation has three separate tape slots located on the front
section of the foot. Insert the tape or ribbon through the appropriate slot and then under the sole of
the foot. (see page 70 for detailed instructions)
The raised markings on the toe of the foot are seam line guides. They indicate the needle positions
to help guide your fabric for accurate seaming.
Presser Foot
Release Lever
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Ovation - BLES8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Ovation - BLES8 in the language / languages: English as an attachment in your email.

The manual is 10,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info