661198
12
Zoom out
Zoom in
Previous page
1/42
Next page
THREADING THE MACHINE
Bobbin Winding
1.Place a spool of thread onto the spool pin with
thread winding off counterclockwise and slide
the appropriate spool cap on spool pin until its
against the spool of thread.
2.Pass thread through the thread guide as shown.
3.Pass thread through the bobbin winder thread
guide.
4.Guide thread from bobbin winder thread guide
through pretension disc as shown.
5.Insert thread through hole in bobbin from inside-out.
6.Place the bobbin on bobbin winder shaft and push
to the right to engage bobbin winder.
7.Hold the end of thread and start the machine.
WINDING THE BOBBIN
If the spool of thread is not correctly placed, the thread may
tangle on the spool.
Make sure you follow the instructions carefully. If you do not cut
the excess thread completely before winding the bobbin, when
the bobbin thread runs low it may tangle around the bobbin and
cause the needle to break.
CAUTION
-10-
8.After the bobbin winds a few turns, stop the
machine and cut the thread as close to the hole as
possible.
9.Start the machine again by pressing foot control
and wind bobbin at medium speed.
10.The bobbin winding will stop when bobbin is full.
11.Push the bobbin and shaft to the left.
Remove the bobbin from the shaft and cut the
thread.
10
11
5
6
7
Pretension disc
8
9
Thread guide
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Jazz - BLMJZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Jazz - BLMJZ in the language / languages: English as an attachment in your email.

The manual is 5,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info