Manual Baby Lock Evolve BLE8W (page 81 of 92) (English)

614492

Zoom out

Zoom in

1/92

1. Open the front cover and raise the presser foot.

2. At the threading port, clip the looper thread that is to be replaced.

(fig.A) Remove thread from under the foot and the upper thread

guides. Replace cone of thread with specialty thread.

3. With machine in locked position (fig.B) set the looper threading port

to U, L, or C according to the looper that is being threaded.

4. Thread specialty thread into the upper thread guides, leaving an 18

inch (40cm) tail above the threading port. (fig.C)

5. Cut a 24 inch (55cm) strand of serger thread and fold in half to form

a thread cradle. Insert the loose ends of the thread cradle into the

port about 1 inch (2.5cm).

6. Holding the cradle loop with left hand, depress the threading lever

with your right hand (fig.D) until the thread ends come out the loop-

er eye. For chain looper, open side door of machine to make sure

thread is in eye of chain looper.

7. Insert the specialty thread tail into the cradle loop (fig.E), pull the

serger thread ends until the specialty thread comes through the

looper eye (fig.F). Discard or set aside the thread cradle.

8. Run upper looper thread under the foot and to the left, cut lower

looper thread to 4 inches (10cm) and leave it hanging loose. Cut

chain looper thread 4inches (10cm) and place in tray. Close side

door of machine. (fig.G)

Thread Cradle for Loopers

E F G

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Evolve BLE8W in the language / languages: English as an attachment in your email.

The manual is 4,28 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Baby Lock Evolve BLE8W Manual

Product: