661191
12
Zoom out
Zoom in
Previous page
1/16
Next page
1. Rotate the yarn & ribbon guide toward the back
of the machine. Align the guide with the top of
the yarn stand pin.
2. Place ribbon on the yarn stand.
3. Insert the ribbon into the slot of the yarn &
ribbon guide.
4. Rotate the ribbon guide toward the front of the
machine.
5. Insert the ribbon into slot of the ribbon
guide.
6. Rotate the handwheel to bring the needle bar to
its highest position.
7. Slide ribbon into the ribbon slot of the cloth
presser.
8. Raise the cloth presser lifter lever.
9. Place fabric under the cloth presser.
10. Lower the cloth presser lifter lever.
ATTENTION: Only guide the fabric towards the
back of the machine while embellishing with ribbon
or using the ribbon slot on the cloth presser to
avoid the ribbon from getting tangled.
NOTE: Maximum width of the ribbon slot is 10mm
therefore ribbon over 10mm is not recommended
for this machine.
If ribbon is narrower than 10mm the needles will
embellish on out
side of ribbon area.
Since there is such a wide variety of ribbons to
select from use care when using dense or thick
ribbons. It is recommended to test sew a sample
using all ribbons before sewing on your project.
T
urn handwheel several times to insure there is no
resist
ance with needle penetration.
6. Ribbon Embellishing
9
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baby Lock Embellisher - EMB12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baby Lock Embellisher - EMB12 in the language / languages: English as an attachment in your email.

The manual is 1,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info