752502
12
Zoom out
Zoom in
Previous page
1/42
Next page
3.5 Swimming Pool Heat Pumps Electrical Wiring
NOTE: Although the unit heat exchanger is electrically isolated from the rest
of the unit, it simply prevents the ow of electricity to or from the pool wa-
ter. Grounding the unit is still required to protect you against short circuits
inside the unit. Bonding is also required.
The unit has a separate molded-in junction box with a standard electrical
conduit nipple already in place. Just remove the screws and the front panel,
feed your supply lines in through the conduit nipple and wire-nut the electric
supply wires to the three connections already in the junction box (four con-
nections if three phase). To complete electrical hookup, connect Heat Pump
by electrical conduit, UF cable or other suitable means as specied (as per-
mitted by local electrical authorities) to a dedicated AC power supply branch
circuit equipped with the proper circuit breaker, disconnect or time delay
fuse protection.
Disconnect - A disconnect means (circuit breaker , fused or un-fused switch)
should be located within sight of and readily accessible from the unit, This
is common practice on commercial and residential air conditioners and heat
pumps. It prevents remotely-energizing unattended equipment and permits
turning o power at the unit while the unit is being serviced.
3.6 Initial startup of the Unit
NOTE- In order for the unit to heat the pool or spa, the lter pump must be
running to circulate water through the heat exchanger.
Start up Procedure - After installation is completed, you should follow these
steps:
1 Turn on your lter pump. Check for water leaks and verify ow to and
from the pool.
2 Turn on the electrical power supply to the unit, then press the key ON/
OFF of wire controller, It should start in several seconds.
3 After running a few minutes make sure the air leaving the top(side) of
the unit is cooler(Between 5-10°C )
4 With the unit operating turn the lter pump o. The unit should also
turn o automatically,
5 Allow the unit and pool pump to run 24 hours per day until desired pool
water temperature is reached. When the water-in temperature reaches
this setting, the unit will slow down for a period of time, if the tempera-
ture is maintained for 45 minutes the unit will turn o. The unit will
now automatically restart (as long as your pool pump is running)when
the pool temperature drops more than 0.2 below set temperature.
3.INSTALLATION AND CONNECTION
12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Azuro Inverter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Azuro Inverter in the language / languages: English as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info