752502
10
Zoom out
Zoom in
Previous page
1/42
Next page
3.2 Swimming Pool Heat Pumps Location
The unit will perform well in any outdoor location provided that the follow-
ing three factors are presented:
1 Fresh Air - 2Electricity - 3Pool lter piping
The unit may be installed virtually anywhere outdoors. For indoor pools
please consult the
supplier. Unlike a gas heater, it has no draft or pilot light problem in a windy
area.
DO NOT place the unit in an enclosed area with a limited air volume, where
the units discharge air will be re-circulated.
DO NOT place the unit to shrubs which can block air inlet. These locations
deny the unit of a continuous source of fresh air which reduces it eciency
and may prevent adequate heat delivery.
3.3 How Close To Your Pool?
Normally, the pool heat pump is installed within 7.5 metres of the pool. The
longer the distance from the pool, the greater the heat loss from the piping.
For the most part ,the piping is buried. Therefore, the heat loss is minimal for
runs of up to15 meters(15 meters to and from the pump = 30 meters total),
unless the ground is wet or the water table is high. A very rough estimate of
heat loss per 30 meters is 0.6 kW-hour,(2000BTU) for every 5°C dierence
in temperature between the pool water and the ground surrounding the pipe,
which translates to about 3% to 5% increase in run time.
3.INSTALLATION AND CONNECTION
10
2.SPECIFICATION
6
3.1 Installation illustration
Installation items:
The factory only provides the main unit and the water unit; the other items in the illustration
are necessary spare parts for the water system ,that provided by users or the installer.
Attention:
Please follow these steps when using for the first time
1.Open valve and charge water.
2.Make sure that the pump and the water-in pipe have been filled with water.
3.Close the valve and start the unit.
ATTN: It is necessary that the water-in pipe is higher than the pool surface.
Chlorinator cell
Water outlet
Pool
Valve
Water supply
Water inletWater pump
Sand filter
(or other type filter)
The schematic diagram is for reference only. Please check the water inlet/outlet label on
the heat pump while plumbing installation.
7
3.INSTALLATION AND CONNECTION
The unit will perform well in any outdoor location provided that the following three factors are
presented:
1. Fresh Air - 2. Electricity - 3. Pool filter piping
The unit may be installed virtually anywhere outdoors. For indoor pools please consult the
supplier. Unlike a gas heater, it has no draft or pilot light problem in a windy area.
DO NOT place the unit in an enclosed area with a limited air volume, where the units
discharge air will be re-circulated.
DO NOT place the unit to shrubs which can block air inlet. These locations deny the unit of a
continuous source of fresh air which reduces it efficiency and may prevent adequate heat
delivery.
3.2 Swimming Pool Heat Pumps Location
Normally, the pool heat pump is installed within 7.5 metres of the pool. The longer the
distance from the pool, the greater the heat loss from the piping. For the most part ,the piping
is buried. Therefore, the heat loss is minimal for runs of up to15 meters(15 meters to and from
the pump = 30 meters total), unless the ground is wet or the water table is high. A very rough
estimate of heat loss per 30 meters is 0.6 kW-hour,(2000BTU) for every 5 difference in
temperature between the pool water and the ground surrounding the pipe, which translates to
about 3% to 5% increase in run time.
3.3 How Close To Your Pool?
Air inlet
Air outlet
2500mm
700mm
300mm
500mm
700mm
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Azuro Inverter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Azuro Inverter in the language / languages: English as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info