764763
8
Zoom out
Zoom in
Previous page
1/18
Next page
EN
14 15
5.3. Drainage and storage
Drainage
1 Check the stopper on the bottom of the pool and the drain cap.
2 Unscrew the drain cap.
3 Remove the stopper on the bottom of the pool. Completely drain all water from the
spa pool.
Once empty, the pool can be cleaned with soap and water.
Storage
5 Press the bubbling button to blow out the water inside the jet holes. Unplug the
pump, remove the lter cartridge from the inner wall of the pool.
6 Use a towel to wipe off the pool, dry 24 hours.
7 Unscrew the valves to deate the pool.
8 Fold the pool.
It is recommended that store the SPA in its original package in a warm dry place.
5.4. Repair kit
Little holes or puncture can be repaired with the repair kit included and glue reserved to
pool liner.
1. Find the leak.
2. Thoroughly clean the area surrounding the leak.
3. Cut a piece of repair material in round shape, which should be larger than the dam-
aged area.
4. Apply adhesive to the underneath side of the patch and around the area to be re-
paired.
5. Put the patch on the damaged area and press down rmly. Allow 12 hours for repair
to dry. After patch has dried, apply glue around the edges for a complete seal (dry 4
hours).
1
5
2
6
3
7 8
Here are some useful tips to help you to diagnose and rectify common sources of
trouble.
Problem Cause Solution
Control panel
screen does not
operate
Check power source
Power failure
Reset the RCD plug / Check if the wiring system is adapted to
the power of the pump unit (1540W)
Call for service if it does not reset
SPA pump does not
heat properly
Temperature set is too low Set to a higher temperature
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Too low water level Fill water to minimum water level
Heating element defective Call for service
Bubble massage
system does not
work
Pump is overheating Cut off the power and wait until the pump has cooled.
Auto shut-down feature (30min) is
activated Press the bubble button to reactivate
Malfunction of the pump unit Call for service if it does not reset
Water ltration does
not work
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Inlet and outlet blocked Clean the inlet and outlet
Air inside the pump Fill water to minimum water level
Malfunction of the pump unit Call for service if it does not reset
Pump leakage
Adaptor seal improperly Replace the seal in the right position
Water leakage from pump body Check the pump body, call for service
Spa pool leakage Spa pool is torn or punctured Use provided repair kit (see chapter 5.4)
Water is not clean
Insufcient ltering time Increase the ltering time
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Pool lled water quality Change the pool water completely
Improper water treatment Refer to the chemical manufacturer’s instructions
6. TROUBLE SHOOTING
6.1. Troubleshooting
8


Need help? Post your question in this forum.

Forumrules
1

Forum

avenli-spa-london

Reset search

  • Spa won’t turn on to pump air into new spa. Error code e3 appears Submitted on 17-2-2024 at 00:12

    Reply Report abuse
  • E4 error message when trying to inflate for first time, London spa!! Submitted on 21-4-2022 at 00:03

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Avenli Spa London at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Avenli Spa London in the language / languages: English as an attachment in your email.

The manual is 6,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Avenli Spa London

Avenli Spa London User Manual - German - 9 pages

Avenli Spa London Usermanual and installation guide - Dutch - 9 pages

Avenli Spa London User Manual - Polish, Swedish, Norwegian - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info