800526
10
Zoom out
Zoom in
Previous page
1/28
Next page
DEX 18 / 21 / 24 / 27 KW
10
Installing connection pieces
1. As shown in the illustration, screw the
cold water connection piece (20) with
the union nut and the ½“ seal onto the
cold water connection.
2. Screw the hot water connection piece
(1) with the union nut and the ½“ seal
onto the hot water connection.
Installing the appliance
1. To open the appliance hood, take off
the faceplate and unscrew the main
hood screw.
• When replacing an appliance, the elec-
trical power supply cable may be con-
nected in the upper part. Only in such
case, follow the instructions in chapter
“Electrical connection from above”.
2. Place the appliance on the heater
bracket (10) so that the threaded rod
of the wall bracket fits in the provided
hole of the appliance. If necessary,
slight corrections are possible by care-
fully bending the threaded rod of the
wall bracket. However, it must be pos-
sible to screw on the water connection
pipes of the appliance without apply-
ing force.
3. Screw the two 3/8“ union nuts of the
appliance‘s water connection pipes,
each with the 3/8“ seal, onto the fit-
tings.
4. Screw the plastic knurled nut onto the
threaded rod of the wall bracket.
Anschlussstücke installieren
1. Schrauben Sie gemäß Abbildung das
Kaltwasseranschlussstück (20) mit
Überwurfmutter und der ½“-Dichtung
an den Kaltwasseranschluss.
2. Schrauben Sie das Warmwasser-
anschlussstück (1) mit Überwurf-
mutter und der ½“-Dichtung an den
Warmwasseranschluss.
Gerät montieren
1. Zum Öffnen des Gehäuses die Blende
abnehmen und die zentrale Hauben-
schraube lösen.
• Im Austauschfall kann es vor kommen,
dass die Elektro zulei tung im obe-
ren Gerätebereich vorhanden ist.
Der Elektroanschluss erfolgt dann
gemäss der Beschreibung im Kapitel
„Elektroanschluss von oben“.
2. Setzen Sie das Gerät auf den Wand-
halter (10), so dass die Gewindestange
des Wandhalters in das vorgesehene
Loch des Gerätes passt. Durch vorsich-
tiges Biegen der Gewinde stange des
Wandhalters lassen sich gegebenen-
falls kleine Korrekturen vornehmen. Die
Wasseranschluss leitungen des Gerätes
müssen sich jedoch ohne Gewalt-
anwendung anschrauben lassen.
3. Schrauben Sie die beiden
3/8“-Überwurfmuttern der Wasser-
anschlussleitungen des Gerätes jeweils
mit der 3/8“-Dichtung auf die instal-
lierten Anschlussstücke.
4. Schrauben Sie die Kunststoffrändel-
mutter auf die Gewindestange des
Wandhalters.
(10)
S
7. Installation 7. Installation
(20)
(1)
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Austria Email DEX21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Austria Email DEX21 in the language / languages: English, German as an attachment in your email.

The manual is 2.99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info