583950

Audiovox AS9233ST Manual

5
Zoom out
Zoom in
Previous page
1/8
Next page
128-8604
5 of 8
2. Turn the ignition switch to the on position.
3. Within 10 seconds, press and release the push-button switch found on the receiver
assembly 3 times.
4. Within 10 seconds turn the ignition switch off, on, off, on, off, on.
(The siren or horn will beep and the lights will flash one time.)
5. Within 10 seconds, begin to press and release the push-button switch to set the tenths
digit.
(As per the example, press and release 5 times to set the tenths digit to 5)
6. Within 10 seconds of the last press of the push-button, turn the ignition switch
off then on.
7. Within 10 seconds, begin to press and release the push-button switch to set the units
digit.
(As per the example, press and release 2 times to set the units digit to 2).
8. Turn the ignition switch to the off position. Immediately observe the LED
flash pattern.
You will note the LED flashing five times, pause, and then flash two times, pause. This
pattern will be repeated three times indicating the new code (52) has been accepted and
stored in memory.
NOTE: If after step 7, the LED flashes a code other than what was just entered,
this indicates that the code has not been changed. You will have to repeat
steps 1 through 7 above being certain to note the following:
Acceptable digits 10ths or units are 1 through 9. The unit will not recog-
nize a 0 (Zero), or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for
more then 5 seconds during any of the above steps, the unit will revert back
to the last successfully stored code.
OPTIONAL IGNITION LOCK/UNLOCK FEATURE :
If your existing factory installed keyless entry system did not include an ignition on/off door
lock and unlock feature, this feature can be activated from this upgrade system. When this
accessory has been added, any time the ignition key is turned to the on position and all vehicle
doors are closed, the doors will lock in 4 seconds. Additionally, any time the ignition key is
turned to the off position, the doors will unlock.
ELIMINATING THE ARM / DISARM CHIRPS :
The normal arming and disarming confirmation chirps can easily be turned off using the valet
pushbutton switch found on the glass mounted receiver assembly. To do this;
1. Turn the ignition key on, and then off.
2. Within 10 seconds of turning the ignition key off, press and release the push-button
valet/override switch 3 times.
3. a. If, before proceeding with step 1, the chirps were on, then you will hear 2
chirps to indicate that the chirps have been turned off.
b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp
to indicate that the chirps have been turned on.
4. Whenever power to the system has been disconnected ( for repair or service
to the vehicle ), the chirps will be activated when the power is re - connected.
To turn the chirps off, simply execute steps 1 through 3 above.
NOTE : Whenever the Arm/Disarm chirps are bypassed, the 3 chirp defective
zone and the 4 chirp intrusion indicator will continue to operate. This
feature will always warn you if a door was left ajar when arming, or the
vehicle was tampered with in your absence.
REMOTE STARTING THE VEHICLE
The System WILL NOT start the vehicle if any one of the following conditions exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4. The glass mounted push-button safety control Is In The Remote Start By-Pass mode.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle
Page 5
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audiovox AS9233ST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audiovox AS9233ST in the language / languages: English as an attachment in your email.

The manual is 0,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info