810507
15
Zoom out
Zoom in
Previous page
1/60
Next page
13
OPERATION PRESCRIPTIONS
Boiler preparation for operation
Before starting the boiler, make sure, that the system is filled with water, deareated and
there is no pressure decrease of the heating water. Check tightness and construction of
flue exhaust. To ensure quality function, the boiler must be attended in conformity with
instructions given in this manual. Only adult person can operate the boiler.
Boiler start-up
Boiler is switched to the stand-by mode by the main switch (left button of double-
switch), placed on the boiler control panel. This is signalized by red control light in the
main switch. Boil-er is started by switching the burner mode switch on (right button of
double switch). This is sig-nalized by control light in the switch. Knob of boiler
thermostat has to be set to the required temperature of heating water. By clockwise
turning the thermostat is the required temperature increased and vice versa. Fuel in the
burner is ignited automatically by el. coil built inside. Boiler operation is automatic and it
is controlled by boiler thermostat and other regulation elements, that can be
connected into boiler terminal (e.g. room thermostat, programmable regulator, ...).
Details about setting the burner parameters are described in the next chapters of this
manual.
ATTENTION! Condensation and condensate leakage may occur by first heat-
up. After longer heating, condesation is eliminated.
f the boiler was out of order for longer period (turned off or faulty), it is necessary
to be more careful when starting it again. After longer idle period it may come to
pump blockage or water leakage from system. Regular and proper cleaning is important
to ensure sustainable output and boiler life-time. Poor cleaning may cause boiler
damage. All boiler door have to be tightly closed during the operation.
Fuel
Approved fuel specification for burners for wood pellets combustion::
Wood pressed pellets
Measured weight:: 600–750 kg/m
3
Heat value: 4,7–5,0 kWh/kg
Size/diameter: 6 mm
Size/length: Attention! Max. 35 mm
Moisture
max.: 12 %
Ash content: 0,5–1 %
Dust content: max. 3 %
Ash smoulder temperature: min. 1100 °C
Fuel must be in conformity with requirements of the norm DIN 51 731
Methods of boiler regulation
Boiler regulation without room thermostat
In this case, the operating mode without room thermostat is set in the boiler electronics
from the factory and boiler is regulated according to the boiler temperature set on the
boiler thermostat placed on the boiler control panel.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK Pellet 30 Automatic Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK Pellet 30 Automatic Plus in the language / languages: English as an attachment in your email.

The manual is 0.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATTACK Pellet 30 Automatic Plus

ATTACK Pellet 30 Automatic Plus User Manual - German - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info