810509
55
Zoom out
Zoom in
Previous page
1/142
Next page
3.4 Installation of the monoblock unit
3.4.1 Installation notes
1) The monoblock unit can be located in a open space, corridor, balcony, and roof.
2) The unit shall be placed in dry and well-ventilated environment;
3) unit mustn't be installed in an environment where volatile, corrosive or flammable liquid or
gas exists.
4) Please don't install unit close to bedroom or living room, because there is some noise when
it's running.
5) When installing the unit in harsh climatic conditions, sub-zero temperatures, snow, humidity..., please
raise the unit above the ground by about 50cm.
6) Please ensure there is drainage system around the location, to drain the condensate water under
defrosting mode.
7) When installing the unit, tilt it by lcm/m for rain water evacuation.
8)
9) Please don't install the indoor control unit and unit in damp locations, otherwise it may
cause short-circuit or corrosion of some components. The unit should be free from corrosive and
moisture surrounding. Otherwise the lifetime of the unit might be shortened.
10) Please ensure enough space around the unit, for better ventilation and maintenance.
Please refer to the illustration below.
monoblock monoblock
Monoblock
monoblock
monoblock
monoblock
monoblock
monoblock
monoblock
If the unit is
installed in humid environment, electronic components may get corroded, or short-circuited because of
heavy humidity.
It's recommended to install an awning above the unit, to protect the snow from clogging in
the air inlet and outlet and ensure the normal running.
Install unit far away from the exhaust port of kitchen, to avoid oil smoke entering
into unit and adhering to heat exchanger. It's hard to clean up.
3. Installation
650mm
400mm
150mm( Back space
1500mm
()
Front
space
500mm
500mm
500mm
( )Above ground
52
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK Inverter R32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK Inverter R32 in the language / languages: English as an attachment in your email.

The manual is 51.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info