810509
54
Zoom out
Zoom in
Previous page
1/142
Next page
3.3.2 Installation
Indoor unit should be mounted on the wall as per procedures below:
1) Take out the expansion bolts and mounting board from accessory and put the mounting board on the
wall horizontally; Mark on the wall the location for bolts through the holes on mounting board.
2) Drill holes with proper diameter for expansion bolts.
3)
4)
5)
6) Hang the indoor unit onto the mounting board and make sure it's placed well before you let go
your hands. The installation is finished.
control
Unscrew the nuts out from the expansion bolts.
Fix the mounting board on the expansion bolts a little bit, but don't be too tight.
Use a hammer to pound the expansion bolts into the drilled holes. Fasten the nuts by turning the wrench
to fix the mounting board on the wall.
control
3. Installation
12 3
45 6
Note:
You must choose very firm wall for installation otherwise the bolts may get loose and unit be damaged!
If it's wood wall, please use self-tapping screws in accessory instead of bolts. Please hang
the mounting board directly onto the wood wall without drilling holes. The wood wall must be firm
enough. Wood walls that are too thin, too brittle or humid are not adequate for installation.
expansion
51
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK Inverter R32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK Inverter R32 in the language / languages: English as an attachment in your email.

The manual is 51.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info