810564
140
Zoom out
Zoom in
Previous page
1/147
Next page
15
ACCUMULATION TANKS
EN
the heat-exchange surfaces of device. Quality of the heating water depends on the quality of the water
lled into the system by starting the operation and quality and amount of the water additionally lled
into the system. Quality of the water additionally lled into the system is dened in the STN 07 7401.
To prepare the D.H.W. in abuilt-in tank or an instantaneous system, it is necessary to install the sa-
fety valve of 6 bar on the cold water inlet. It is also necessary to ensure the treatment of the D.H.W.
against the limescale and dirts from the water distribution network.
Hardness of water cannot exceed 5 mval / l. Warranty does not relate to the blockage of the tank or
the ow copper exchanger by alimescale.
7. MAINTENANCE
To clean the external parts of the tank you need awet cloth and asuitable detergent. Never use
abrasive cleaners, diluents, petroleum-based cleaners, etc.
Check the tightness of joints on the ange of the HR, HRS tank at least once ayear, eventually x the
nuts. If there is untightness even after xing the nuts, replace the sealing under the ange.
Maintenance of the accumulation tank HR, HRS concerns test and replacement of the anode rod.
The magnesium anode adjusts the electric potential inside the tank to the value preventing corro-
sion of the tank. Theoretical life-time of the anode takes 2 years of operation, but it changes accor-
ding to the callosity and the chemical composition of water at the place, where the tank is used. It
is recommended to make a test every 6 months and in the case of need, to replace the anode rod.
This additional protection element should be considered as important.
Procedure of replacement of the anode rod:
1. Discharge approximately 1/3 of the water in the tank
Procedure: close the valve at the water inlet into the tank,
open the valve of hot water on the mixing tap,
open the discharge valve of the tank.
2. Undo the upper cover of the accumulation tank.
3. Use asuitable tool to screw the anode out.
4. Install anew anode and mount the dismantled parts back.
5. Fill the tank with water, pressurize it and check the tightness.
The anode must be replaced only by aspecialized service company!
8. DISPOSAL
Packaging must be disposed following the valid prescriptions.
After expiration of the lifetime it is necessary to dispose the product in conformity with the legal
prescriptions.
140


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK HR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK HR in the language / languages: English, German, French as an attachment in your email.

The manual is 9.12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info