810555
14
Zoom out
Zoom in
Previous page
1/28
Next page
ČSN 07 0240:1993 - Water and low pressure steam
requested (difference between the temperature of boiler boilers basic rules
when the boiler start to heat and the temperature
ČSN 07 7401:1992 - Water and steam for heating
requested) setting only by an authorized service man!! energetic equipments
Notice: If you increase hysteresis you can reduce the
ČSN 33 1310:1990 - Electrotechnical rules. Safety
number of cycles during relays switching on/off and rules for electric equipments used by person without
elongate their lifetime. electric qualification
ČSN 33 2000 -… Electrotechnical rules.
E - Go back to the production setting
ČSN 33 2130:1985 - Electrotechnical rules. Inside
If you have set wrong parameters than it is possible for electrical distribution system.
you to go back to the production setting. Values of
ČSN 33 2180:1980 - Electrotechnical rules, connection
parameters will be according below mentioned table: of electric appliances.
Going back to the production setting steps:
ČSN EN 50110-1:2005 - Service and work with
switch off the boiler by main switcher electrical appliances
push in the same time the buttons ČSN EN 55014:2001 -Electromagnetic compatibility
switch on the boiler by main switcher in the same time requirements for home appliances, electric tools and
as you hold pushing the buttons till the similar appliances.
moment when on the display there is E lightingí EČSN EN 60335-1+A55:1997 - Safety of home electric
release the buttons and now the boiler is set according appliances and for similar purposes.
to the production setting. ČSN EN 61000 -…Electromagnetic compatibility
(EMC)
2.5. Breakdowns, defects Law No. 22/1997 Technical requirements for
products
In case that the boiler is broken then on the display there Government direction No. 178/1997 defined
is E blinking with the number of the breakdown. technical requirements for construction products +
List of breakdowns: enclosure No. 1 basic requirements.
Notice No. 48/1982 basic requirements to assure
labour protection and safety of technical equipments
3.2 Placement of the boiler in the
room
Room where the boiler will be placed and mounted on
the wall has to be in accordance with normal
environment AA5/AB5 according to ČSN 33 2000 3.
It is not allowed for boilers to be installed in bathrooms,
wash rooms, shower rooms in place 0, 1, 2, 3 according
to the rule ČSN 33 2000-7-701.
Concerning fire protection and safety the rule ČSN 06
1008 is valid and there is stated minimal distance from
flammable objects.
We recommend enlarging these distances to have
Breakdown of the boiler has to be minimal space for easier service and manipulation:
repair only by professional person!
In case that you have a - 500 mm from the front side
defect/breakdown and it is necessary - 600 mm from the top
to repair it only by an authorized - 200 mm from the side
service man, don't try to repair the
boiler by yourself.
Attention There is threat of casualty 3.3 Mounting of the boiler on the
by electric current. wall
Mounting is carried out by 2 screws or hooks which the
3. Installation boiler is hanged on through 2 inlets with spacing of holes
3.1 Norms and regulations 280 mm on the frame of the boiler.
For safety operation, projection, mounting, operation
and service of boiler is valid below mentioned norms and 3.4 Electroinstallation
regulations: 3.4.1 Boiler connection to electric supply net
ČSN 06 0310:2006 - Heating systems in buildings For boiler connection to electric supply net it is
projection and mounting. necessary for user to have a license from the local
ČSN 06 0830:2006 - Heating systems in buildings energetic distribution organization. Boiler input is not
safety and protection equipment allowed to be bigger than the input stated in the license.
ČSN 06 1008:1998 - Fire safety of heating appliances
14
breakdown
marking specification repair breakdown reset
E1
Temperature of heating
water higher than 99° C,
or temperature sensor is
broken (for example short
Call your service man Automatically
circuit)
E2
Overheated – the boiler
is out of operation
through the emergency
thermostat.
Remove the blocking of
Call your service man
the emergency
thermostat (it is
necessary to know the
cause of overheating)
E3
Lost of pressure –
pressure of heating
Check the tightness of
system decreased
heating system and fulfill
water to have pressure Automatically
higher than 0,4 bar.
00
Disconnected or invalid
temperature sensor or
If temperature is not
temperature below 0° C
increasing, call your
service man.
Automatically
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK Electric Easy at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK Electric Easy in the language / languages: English as an attachment in your email.

The manual is 4.4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info