810555
11
Zoom out
Zoom in
Previous page
1/28
Next page
without setting (without using / ,the boiler returns
2.2. Boiler switching ON/OFF to mode before setting.
Hold the button or and the value will role
Is done with the switcher 0/1 placed on the lower side of automatically up or down .
boiler in the right lower corner (see the picture 1.6).
After boiler switching on you can see information on the 2.3.1 Operation mode heating heating water
display: on the display there is instantaneous temperature.
EL - - type of the boiler
6A - software number Without the room thermostat connected
1.0 - software modification ( např. 1.0)
The switch board and inlet supply
connectors of clamps and the inlet
supply connector are under voltage!
Disconnect the boiler from the main
inlet supply.
2.3 Modes
Important knowledge for setting:
During temperature setting the point between
numbers are lighting.
During pause longer than 5 s the boiler returns to point
before setting.In case of mistake setting (for example
parameters) it is possible to wait 5 s and the boiler
returns back or it is possible to push the button ENTER
Electric Easy
11
2. Maintanance
2.1 Control panel
8.0.
information about instantaneous/set temperature
mode information
breakdown information
information about parameters setting
change o the parameter set
-
change of the parameter set +
point is lighting = setting
point is not lighting = operation
point is lighting = only 1 heating
element is on
point is not lighting = no heating
element is on
point is blinking = below/overvoltage in
supply net
short pushing
- setting confirmation in memory
- return from the mode Stand-by
- frame for parameters setting
long pushing (approx. 3 s)
- going to mode Stand-by
information about instantaneous
pressure of heating system.
4
55
6
1 - boiler
4 - heating system
5 - shut off valve
6 - filter
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK Electric Easy at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK Electric Easy in the language / languages: English as an attachment in your email.

The manual is 4.4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info