810412
37
Zoom out
Zoom in
Previous page
1/66
Next page
Operation and Maintenance Manual - EN
EN
www.atmos.cz EN-37
• Parameter S28 - deactivation difference of function S26 = 1… (3 K)
If the temperature on the solar panel (TSV) exceeds the temperature in the lower part of the tank
by the deactivation difference, the boiler deactivation function will be switched from the middle
TK sensor to the bottom TS sensor.
If a function for solar panel pump control is activated directly from the boiler regulation (S6 = 14
or S14 = 4), the same logic will be used to activate the solar pump.
• Parameter S29 - is the function for delaying the automatic switching from the TK sensor back to
the TS sensor for controlling the burner based on two temperatures (sensors, S15 = 3)... (0 hours)
This function will cause the function for deactivating the burner to be switched from the middle
TK sensor to the bottom TS sensor after the time listed in parameter S29 passes, if the temperature
on the solar panel TSV is lower or greater only by the deactivation difference (Parameter S28) than
the temperature in the lower part of the tank where the solar exchange is located.
The set value means the number of hours, e.g.: S29 = 2 means a switch delay of 2 hours.
• Parameter S30 - is the function of the minimal operating time of the solar pump when the
conditions for its activation and then deactivation are met (function S15 = 3)… (3 min)
The set value means the number of minutes, e.g.: S30 = 3 means 3 minutes
• Parameter S31 - characterizes the required temperature TS in the lower part of the accumulation
tank where the solar exchanger is located, during the function of charging the accumulation tank
by the solar collector. (function S15 = 3)… (75 °C)
Once it is reached, the solar pump will be turned off.
• Parameter S32 - characterizes the maximum temperature TV in the accumulation tank during the
function of charging the accumulation tank by the solar collector (function S15 = 3)… (100 °C)
The solar pump will be turned off if it is exceeded.
• Parameter S33 - characterizes the maximum temperature TSV of the solar collector, for which the
solar pump will still remain in operation (function S15 = 3)… (115 °C)
The solar pump will be turned off if it is exceeded.
• Parameter S34 - is the function of automatically starting the pellet burner (AUTOSTART) after
the wood burns out. The function is specially created for SP(X) burners, however it may also be
used for two separate boilers… (0)
a) S34 = 0…. The automatic start function is off
b) S34 = 1…. The automatic start function is on. The pellet burner will be turned on when the
temperature of exhausts TSV drops below the set value (S36 = 80), e.g. below 80 °C
c) S34 = 2…. The automatic start function is on. The pellet burner will be turned on when two
conditions are met:
- the temperature of the boiler TK drops below the set value (S35 = 75), e.g. below 75 °C
- the temperature of exhausts TSV drops below the set value (S36 = 80), e.g. below 80 °C
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atmos A85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atmos A85 in the language / languages: English as an attachment in your email.

The manual is 2.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Atmos A85

Atmos A85 User Manual - German - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info