CAUTION: Before removing the plastic cover, make sure the power is turned off to avoid any risk of injury or electric shock.
1.USER MAINTENANCE
Operates once a month the discharge of the safety valve to prevent scaling deposit and verify that the safety device is not blocked. If
this is not done, damage may be caused and the guarantee invalidated. For an installation with a booster pump; before starting up, after a long
period of disuse, turn the rotor following the advice in the manufacturer’s instructions.
2.MAINTENANCE BY A QUALIFIED PERSON
- Scaling: Remove the scale sludge. Do not scrape or hammer the lime scale deposited on the casing, as this may damage the lining.
- Magnesium anode: change the magnesium anode every 2 years or when its diameter is lower than 10 mm.
- Heating element: the replacement of a sheathed heating element involves draining of the water heater and replacement of the flange gasket.
Reassemble the heating element, reasonably tight nuts (cross tightening), check that there is no leakage after the first heating-up, tighten
again if necessary
- Drain: Turn off power and cold water supply. Open hot water taps and drain valve of the safety device.
Spare parts list: thermostat, flange gasket, heating element, heating light indicator, magnesium anode, connection wires, electric switch. The
guarantee requires genuine manufacturer’s parts to be used.
Advice to the user
When the water has a TH > 20°f, it is recommended that this be treated. When a softener is used, the water hardness must remain
above 15°f.
In case of prolonged absence, especially in winter, drain your appliance following the procedure above.
SCOPE OF THE GUARANTEE
The water heater must be installed, used and maintained according to best practice and conform to the standards in force in the country in which
it is installed and to the instructions contained in this document. In the European Unionthis appliance is covered by the statutory guarantee
accorded to consumers in accordance with directive 1999/44/CE. This guarantee comes into force when the appliance is delivered to the
consumer. In addition to the legal guarantee, certain items are covered by an extra guarantee relating only to the free exchange of the tank and of
components accepted as defective. It does not include the cost of replacement or carriage. Refer to the table below. This commercial guarantee
does not affect your statutory rights. It applies within the country where the product was acquired, provided it is also installed in the same country.
The dealer must be informed of any damage before the product is exchanged under guarantee and the appliance will remain available for
inspection by experts from the insurance company and the manufacturer.
Exclusions: Wear parts: magnesium anodes. Equipment which cannot be assessed (access difficult for repair, maintenance or assessment).
Equipment exposed to abnormal environmental conditions: frost, bad weather, water which is abnormally aggressive or outside drinking
standards, electrical supply with large spikes. Equipment installed without observing current standards in the country of installation: the absence
or incorrect fitting of safety devices, abnormal corrosion due to incorrect water fitments (iron/copper contact), incorrect earthing, inadequate cable
thickness, non-observance of the connection drawings shown in these instructions. Equipment not maintained in accordance with these
instructions. Repairs or replacement of parts or components in the equipment not carried out or authorised by the company responsible for the
guarantee. Changing a component does not extend the life of the guarantee.
The products illustrated in these instructions may be modified at any time to reflect changes in manufacture and current norms.
To claim under guarantee, contact your installer or dealer. If necessary, contact:
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Atlantic Ingenio at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Atlantic Ingenio in the language / languages: English, French, Polish as an attachment in your email.
The manual is 3,59 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
