519915
20
Zoom out
Zoom in
Previous page
1/100
Next page
19
Blade guard adjustments
The adjustment of the blade guard must be checked after each saw blade
and table insert change.
Transport
Before each transport:
Switch off device
Wait unitl the saw comes to a stop.
Pull out power plug
Accessories such as stops must be securely
mounted or clamped on the machine.
Storage
Pull out power plug
Store unused equipment in a dry, locked place out of the reach of children.
Before a longer period of storage carry out the following to extend the saw
service life and ensure an easy operating:
thoroughly clean the device
treat all movable parts with an environmentally friendly oil
L
Never use any grease!
Guarantee
Please observe the enclosed terms of guarantee.
Possible faults
Before each fault elimination:
Switch off device
Wait unitl the saw comes to a stop.
Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault Possible cause Remedy
Machine fails to start after switching on
Power failure
Extension cable defect
Motor or switch defect
Check the fuse.
Check cable, no longer use defect cable
Have motor or switch checked by an approved electrician or
replaced by original spare parts
Machine stops while cutting
Saw blade blunt
Feed is too great
Replace saw blade (24)
Allow motor to cool and proceed working with less pressure
Burned spots at the cut areas
Saw blade blunt Replace saw blade
Saw vibrates
Saw blade is warped
Saw blade not properly mounted
Replace saw blade
Mount saw blade properly
Decelaration too slow (time to dead stop
>10 sec.)
Motor brake defective
Brake disk worn
Have motor or switch checked by an approved electrician or
replaced by original spare parts
Motor generates insufficient power and
becomes too hot.
Three-phase motor is running on the second
phase.
Extension cable too long or cable cross-
section too small.
Blunt saw blade.
The fuses and the supply lines must be checked by an
electrician.
See "Setting into Operation".
The saw blade must be resharpened or replaced
Safety guard not freely movable
Screws excessively tightened.
Loosen the screws (D) to the extent that the safety guard can
be moved (Fig. 12).
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika BTH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika BTH in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 3,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info