519289
27
Zoom out
Zoom in
Previous page
1/101
Next page
Possible faults
Before each fault clearance
switch off device
wait for stop of chain saw
pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault Possible cause Removal
Machine fails to start after
switching on or switches off
during idle running
Power failure
Extension cable defect
Motor or switch defect
Saw blade sticks
Replace fuse
Check cable, no longer use defect cable
Have motor or switch checked by an
approved electrician or replaced by original
spare parts
Remove the cause of the jam.
Machine stops while cutting
Saw blade blunt
Feed is too great
Motor protecting switch has tripped
Replace saw blade
Allow motor to cool and proceed working
with less pressure
Switch motor back on after cooling ("Motor
protection", page 22)
Workpiece sticks when feeding
Saw blade is dull
The longitudinal or parallel stop is not
parallel to the saw blade, see p. 23
Hold the workpiece firmly and switch the
motor off immediately. The have the saw
blade sharpened or renew
Readjust the scale, see p. 23
Burned spots at the cut areas
Saw blade is not suitable for the work step or
is dull
Replace saw blade or have it sharpened
Chip outlet is clogged
No exhaust system connected
Exhaust power too weak
Switch off saw, remove chips and connect
exhaust system
Switch off saw, remove chips and increase
exhaust power (air velocity 20 m/sec at chip
exhaust neck.
Motor running, saw blade will not
turn.
V-belt too loose or defect Contact an authorised customer service
workshop
Saw vibrates
Saw blade is warped
Saw blade not properly mounted
Replace saw blade
Mount saw blade properly
26
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Atika BMS250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Atika BMS250 in the language / languages: English, German, Dutch, Danish, French, Polish, Swedish as an attachment in your email.

The manual is 4,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info