121861

ATAG WU 9011 GC Manual

12
Zoom out
Zoom in
Previous page
1/13
Next page
• Extractor version
When installed in this way the appliance expels fumes outside,
either through a perimeter wall or through existing ducting.
It is therefore necessary to purchase a non- ammable air
exhaust tube (not supplied) which complies with all current
legislation and connect it to  ange N (Fig.1B).
• Filter hood
Please note:
In order to transform the hood from EXTRACTOR HOOD
into FILTER HOOD the carbon  lters must be ordered at your
distributor as accessory.
We have two different types of Kit, one with extractable carbon
filters (Fig.7) and the other one with re-usable carbon filters
(washable). (Fig.8)
- To replace the extractable active carbon filters X, pull lever
outwards as shown in Fig.7
- To replace re-usable carbon filters Y, remove the brackets
from their seat, pulling them outwards. (Fig.8)
If you find a bracket such as the one indicated in Fig.9 included
in the product packaging, this should be fixed to the hood
using the supplied screws.
USE AND MAINTENANCE
• We recommend that the cooker hood is switched on before
any food is cooked.
We also recommend that the appliance is left running for
15 minutes after the food is cooked, in order to thoroughly
eliminate all contaminated air.
The e ective performance of the cooker hood depends on
constant maintenance; the anti-grease  lter and the active
carbon  lter both require special attention.
• The anti-grease  lter is used to trap any grease particles
suspended in the air, therefore is subject to saturation (the
time it takes for the  lter to become saturated depends on
the way in which the appliance is used).
- To prevent potential  re hazards, the anti-grease  lters should
be washed a minimum of every 2 months (it is possible to use
the dishwasher for this task).
- After a few washes, the colour of the  lters may change. This
does not mean they have to be replaced.
If the replacement and washing instructions are not followed,
the anti-grease  lters may present a  re hazard.
• The active carbon  lters are used to purify the air which is
released back into the room.
The  lters are not washable or re-usable and must be replaced
at least once every four months.
The active carbon  lter saturation level depends on the fre-
quency with which the appliance is used, the type of cooking
performed and the regularity with which the anti-grease
lters are cleaned.
• Clean the cooker hood frequently, both inside and outside,
using a cloth which has been dampened with denatured
alcohol or neutral, non-abrasive liquid detergents.
• The light on the cooker hood is designed for use during
cooking and not for general room illumination.
Extended use of the light reduces the average duration of
the bulb.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 13 -
… 12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG WU 9011 GC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG WU 9011 GC in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info