108869

ATAG WCA .1 Manual

32
Zoom out
Zoom in
Previous page
1/37
Next page
GB 7
maintenance
cleaning
hood
enamelled extractor hoods
Clean the extractor hood with soap and a soft cloth. Then
rinse with clean water. Do not use aggressive cleaning
agents, such as soda. The enamel will remain attractive if you
polish it with wax from time to time.
stainless steel extractor hoods
For cleaning the stainless steel parts you can best use a mild
cleaning agent (washing-up liquid) and a damp cloth. Dry with
kitchen paper or a dry cloth.
The stainless steel regains its shine if you occasionally use a
stainless-steel care product or polish. The polish applies a
dirt-resistant layer to the stainless steel. Always clean the
stainless steel in the direction of polishing.
ATAG supplies cleaning and maintenance agents for extractor
hoods. For information on availability, please contact the
consumer department (see warranty conditions for the phone
numbers).
Never use abrasive cleaning agents (such as green scourers
or other scouring pads) or polishing cleaning agents (such as
liquid abrasives). Never use caustic agents. These can attack
the stainless steel.
GB 6
operation
switching on
introduction
Set the extraction capacity and lighting on the control panel.
Read on this page how to use the facilities.
switching on
models without motor
Press the on button (1).
The electrically powered flap is opened.
NB: do not leave the flap switched on for more than
12 hours at a time.
models with motor
Press the fan button for the desired setting (1, 2, 3).
1 is the lowest setting, 3 the highest.
The fan will be switched on at the desired setting.
switch off
models without motor
Press the off button ( ).
The electrically powered flap is closed.
models with motor
Press the off button ( ).
The fan is switched off.
switching lighting on
Press the lighting button ( ).
The lighting is switched on.
switching lighting off
Press the light switch ( ) again.
The lighting is switched off.
on button
lighting button
fan buttons
off button
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG WCA .1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG WCA .1 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info