GB 9
operation
microwave function
introduction
The combi-microwave oven can function as a microwave
oven, hot-air oven and grill. In addition, you can choose the
combination functions. These combine the microwave
function with hot air or the grill.
The following pages contain instructions for selecting these
functions. The cooking information describes possible
applications.
direct start (only microwave function)
1 Press 'start'.
The microwave function starts on full power for
30 seconds.
You can increase the cooking time to a maximum of five
minutes by pressing start several times.
microwave function
1 Press 'microwave oven'.
The display shows:
– the function selected;
– the power level set;
– the time symbol (blinks to indicate that you still have to
set a time).
2 Set the power level required (if desired).
You can select from 80, 150, 250, 350, 500, 600, 800 and
900 Watt.
3 Set the cooking time required.
In the display 'start' blinks, to indicate that the appliance
is ready to be switched on.
4 Press 'start' to switch the microwave oven on.
The display shows the remaining cooking time.
At the end of the cooking time, you will hear a signal. The
microwave oven switches off. For a period of 10 minutes the
signal sounds constantly at one minute intervals, until the
stop button is pressed or the door is opened.
1
2
3
4
1
GB 8
bringing the oven into operation
before you start cooking
cleaning the microwave oven and accessories
Remove the accessories from the combi-microwave oven
and clean the oven with a mild cleaning agent.
Switch the hot-air function on for one hour at 250 °C (see
page 12).
Protective greases used during manufacture will then be
removed.
remark
When the oven is heated strongly for the first time, it will
have a 'new' smell. This is normal. Switch the extractor hood
on if necessary or open a window.
After the oven has cooled down, clean it with warm water.
setting the time
1 Press the time selector button.
The clock symbol starts to blink.
2 Set the correct time using the rotary knob.
The start symbol starts to blink.
3 Press Start and the time has been set. The Stop or time
selector button could also be used.
You can hide the time. Press the time selector button for
3 seconds and the time will disappear from the display. When
you press the time selector switch again, the time will
reappear.
1
3
2
