Manual ATAG KD7..G (page 29 of 70) (English, German, Dutch, French)

481266

Zoom out

Zoom in

1/70

removal of ice container

You remove the ice container as follows:

Lift up the left front corner. Draw the container

straight towards you, at the same time

supporting the container at the front and on the

right.

The ice container is fitted as follows:

Slide the ice container to the rear until the lip

slips into the groove in the shelf.

If the container cannot be slid fully to the rear,

remove it again.

Turn the knob of the drive mechanism a quarter

turn and slide the container into the freezer

section again.

Old ice cubes will turn cloudy and taste stale. In

that case, empty the ice container and rinse it in

lukewarm water. Allow the container to dry

thoroughly before you replace it. This will prevent

ice cubes freezing on the sweeper arm.

Set the icemaker's sensor to setting (= off) if:

– the water supply is cut off for some hours;

– the ice container is removed for some time;

– you go on holiday and turn off the water.

fitting the ice container

drive

mechanism

direction of turn

if you do not use much ice

icemaker's sensor in setting

ice and water dispensing (continued)

Sometimes, a small mound of snow will form in the

crushed ice discharge opening. This is normal and

occurs when you often use crushed ice. This snow

will soon evaporate.

Release the dispenser switch. Hold a glass or

ice bucket under the discharge opening for a

few more seconds, in order to catch the last ice

cubes, crushed ice or drops of water.

Do not let any water get into the tray under the

grille of the dispenser opening. This is a drip tray,

not a drain!

Clean the drip tray frequently, so that no deposits

can form in it.

Remove the grille by pushing on the right side

of it.

The icemaker deposits eight ice cubes at a time in

the ice container. It is normal for some of the ice

cubes to freeze together.

If you do not use many ice cubes, large chunks of

ice may form in the container. The dispenser then

gets blocked. If this happens:

1 . Remove the ice container from the fre e z e r

s e c t i o n .

2 . Break the ice cubes loose with your hand.

3 . Throw away large chunks of ice.

4 . Replace the container in the freezer section

before the remaining ice cubes melt and freeze

to stop ice and water dispensing

remove grille

formation of chunks of ice

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of ATAG KD7..G in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

ATAG KD7..G Manual

Product: