76319
24
Zoom out
Zoom in
Previous page
1/35
Next page
24
* Depending on model and options
Defrosting
The refrigerator and Climat-Freshbox compartment
defrost automatically. The defrost water is evaporated by the heat
from the compressor.
The freezer compartment*
After a long period of operation, a thick layer of frost or ice can
build up inside the freezer compartment. This increases energy
consumption. You should therefore defrost the freezer compart-
ment regularly:
W To defrost, switch off the appliance: Disconnect the appliance
from the mains or press the on/off button so that the temperature
display goes out. If the display does not go out, the child-proof
lock is
activated.
W Wrap the frozen goods in newspaper or a blanket and store in
a cool place.
W To speed up the defrosting proc-
ess place a saucepan of hot but
not boiling water in the compart-
ment.
Do not use electric heaters
or steam cleaners, defrost-
ing sprays or naked flames for defrosting nor
any sharp objects for removing the ice. Risk of
injury and damage!
W Leave the freezer compartment door and the appliance door
open when defrosting. Mop up the defrost water with a sponge
or cloth. Clean the appliance afterwards.
Cleaning
W Before cleaning, always switch off the appli-
ance. Disconnect from the mains or unscrew
or switch off the fuse.
W Clean the inside and equipment by hand with lukewarm
water and a little detergent. Because of the risk of injury and
damage to the appliance, steam cleaning equipment should
not be used.
W We recommend using a soft cloth and an all-purpose cleaner
with a neutral pH value.
- Do not use abrasive sponges or scourers, do not use concen-
trated cleaning agents and never use cleaning agents containing
sand, chloride or acid or chemical solvents.
W Do not allow cleaning water to run down the drain gulley or to
penetrate the ventilation grilles or electrical components. Wipe
the appliance dry.
- Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
W The butter dish* can be washed in a dishwasher. The racks,
Defrosting, cleaning
shelves and other components should be
cleaned by hand.
W Remove the shelves as shown in the il-
lustration:
- Lift the glass shelf, align the recess over
the support, tilt to the side and remove at
an angle.
- Always insert shelves with the raised edge
at the back pointing upwards, otherwise food may freeze onto
the rear wall.
W Always remove the top door rack (butter and cheese compart-
ment) together with the flap*. Then press one of the side walls
carefully to the outside to release the flap pin. The flap can then
be lifted out.
- The shelves and door racks can be dismantled for cleaning.
Remove the trims and sides from the glass shelves.
- Remove the protective film from the decorative trims (see
fig.).
W To clean the Climat-Freshbox drawers 1, pull the drawers
right out and lift out (fig.
L).
Important: To prevent damage, the fully extended guide
rails
3 should be re-inserted immediately.
- To insert the drawers, place on the fully extended rails and slide
in (fig.
M).
fig.
L fig. M
- Having removed the drawers, carefully pull the drawer
cover
with humidity control 2 towards you and remove down-
wards.
When re-inserting, proceed in reverse order. Slide the projecting
sections of the cover into the supports and click into place.
W Clean the drain hole in the rear wall
behind the second Climat-Freshbox
drawer frequently,
arrow in illustra-
tion. If necessary, clean with a
thin object, e.g. a cotton swab or
similar.
W
Then connect/switch on the appliance.
If the appliance is to be
left switched off for any length of time
empty the appliance, disconnect from the mains, clean as described
above and leave the door open so as to avoid odours.
1
2
1
2
3
1
1
2
3
2
Making ice cubes
W Fill the ice-cube tray three-quarters
full with water.
W Place the ice-cube tray in the appli-
ance and leave it to freeze.
W The ice cubes can be removed from
the tray by twisting or by holding
upside down for a short time under
running water.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG KD 8122 BF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG KD 8122 BF in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info