2624

ATAG HI311M - installatievoorschrift Manual

46
Zoom out
Zoom in
Previous page
1/49
Next page
GB 16 GB 17
extra facilities
beep
switching the beep off/on
The beep, which can be heard when the buttons are pressed,
can be switched off or on.
switching the beep off
1 Switch the front-left cooking zone on and then off by
pressing the on/off button twice.
2 Immediately afterwards, press the – button belonging to
the front-left cooking zone for five seconds.
A beep confirms the setting that has just been selected.
The beep for the front-left and rear-left cooking zones is now
switched off.
Repeat this operation for the right-hand cooking zones using
the on/off button and the – button for the front-right cooking
zone.
switching the beep on
1 Switch the front-left cooking zone on and then off by
pressing the on/off button twice.
2 Immediately afterwards, press the – button belonging to
the front-left cooking zone for five seconds.
A beep confirms the setting that has just been selected.
The beep for the front-left and rear-left cooking zones is now
switched on.
Repeat this operation for the right-hand cooking zones using
the on/off button and the – button for the front-right cooking
zone.
on/off button front-
left cooking zone
– button for front-left
cooking zone
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
faults
what should I do if…
fault
The appliance does not work
and the lights are not on.
The hob does not work.
F9 appears in the display.
The hob does not work.
F0 appears in the display.
The fan switches on
spontaneously.
The cooking zone suddenly
switches off.
Message F7 appears.
The lights keep blinking after
switching on.
Appliance does not work.
The appliance switches off.
cause
No electricity.
The appliance has been
connected incorrectly.
Ambient temperature was
too low (5 °C) when the hob
was not connected to the
electricity supply.
The appliance is checking
itself after a power failure.
Insufficient ventilation.
Overheating of the
electronics in the hob.
Unsuitable pans.
Poor electrical contact.
Appliance is locked.
Two pans are touching each
other or a pan comes into
contact with the wall.
solution
Check the electrical
installation (main fuse(s),
connection).
Ask the installer to connect
the appliance again in
accordance with the wiring
diagram.
Wait for about ten minutes
after connecting. The
message disappears.
The fan switches itself off.
Check the ventilation
openings.
Let the appliance cool down.
Press any button and the
message disappears. Start
again on a lower setting.
Use a suitable pan (see pages
21 and 22).
Check whether the cable has
been knocked against by the
drawer. In that case, have the
connection changed by the
installer.
Press the key symbol
for three seconds
continuously.
Make sure that the pans
stand clear.
… 46 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG HI311M - installatievoorschrift at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG HI311M - installatievoorschrift in the language / languages: Dutch as an attachment in your email.

The manual is 0,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info