111331
140
Zoom out
Zoom in
Previous page
1/180
Next page
YOUR COFFEE MACHINE
8 Faults
GB 34
PROBLEM CAUSE SOLUTION
Ground co ee was used
(instead of co ee beans)
and the machine will not
dispense any co ee.
e co ee strength/
preground co ee” knob is
not turned completely to
the left
or right
and the appliance used
both preground co ee and
co ee ground by the mill
mechanism.
Preground co ee was inserted
whilst the machine was
switched o .
Carefully clean the inside of
the machine (see page 12).
Repeat the process, but  rst
turn the “co ee strength/
preground co eeknob
completely to the left
or
right
(see 5.2.5 on
page 14).
Remove the brewing unit and
carefully clean the insided of
the machine (see 6.1.1 and
6.1.2 on page 21, 22 and 23).
Repeat the process with the
machine switched on.
Co ee does not come out
of the spouts on the co ee
dispenser but out of the
service door at the side.
e holes on the co ee
dispenser are blocked with
dried on co ee.
e swing drawer on the
inside of the service hatch is
blocked and will not move.
Remove the dried on co ee
with a needle (see 6.1.1 on
page 21,  g. 24).
Carefully clean the swing
drawer, particulary in the area
around the hinges so that
these continue to move.
Milk is frothed up too much
or too little.
Wrong setting of the slider on
the lid of the milk container.
If the milk is not frothy
enough, the milk container
may not be correctly in place.
You can set the amount of
froth on the milk to any
level using the slider on the
lid ( g. 19 on page 17):
‘CAPPUCCINO’ (very frothy
milk) or ‘CAFFELATTE’
(not so frothy milk).
Put the milk container
correctly in place. ( g. 18 on
page 17).
140


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG CM 4111 AC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG CM 4111 AC in the language / languages: Dutch as an attachment in your email.

The manual is 3,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info