495986
79
Zoom out
Zoom in
Previous page
1/97
Next page
TD 92477EN
15 June 2012 / Ver. G
User Manual
Ascom d62 DECT Handset
75
Error or Warning Messages
Display shows Probable cause Action or comment
No access The network is in range, but no
access rights.
Switch handset off and then
switch it on again or contact
system administrator.
No System. The handset
beeps once a minute
(during max 30
minutes) with a low
tone followed by a high
tone (if enabled, the
vibrator also follows the
beeps).
The handset is out of coverage or
handset is defective.
Stop the beep with the Sound
off key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or
contact system administrator.
The message Failed is
displayed when the
handset tries to
download an ECG
waveform image.
The IP-DECT wireless connection
point is overloaded with too many
calls.
Go see the patient. The ECG
Monitoring functionality will
start working when the IP-DECT
connection point is no longer
overloaded.
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown
in English.
The handset is defective. Select the reset option on the
middle soft key and upgrade
the handset’s software to
version 3.0.0 or greater. If this
is not available or the problem
persists send the handset for
service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Easy replacement procedure not
followed correctly or failure during
easy replacement procedure.
Send the handset for service.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via PDM
or do a factory reset via PDM.
Battery low, charge now The battery level is low. Charge or replace the battery.
Phonebook is not
available at the
moment.
The phonebook does not respond,
not available at the moment.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Voice mail number not
defined
There is no Voice mail number
defined in the handset.
Define a Voice mail number via
PDM.
79


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ascom d62 DECT Handset at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ascom d62 DECT Handset in the language / languages: English as an attachment in your email.

The manual is 9,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info