736695

AS Motor AS 940 Sherpa 4 WD RC Manual

11
Zoom out
Zoom in
Previous page
1/60
Next page
Safety instructions
11
When the uphill wheels encounter obstacles such as roots,
branches, rocks, mounds etc., the device can tilt or slip.
– Only drive when you know about the terrain conditions and
terrain is free of obstacles.
– Pay attention to bumps, holes, and other visible hazards.
– Do not drive close to danger zones (e.g. walls, slopes,
steep declines, water edges etc.).
Danger due to uncontrolled slipping
Only park the device on flat surfaces.
Proceed with extreme caution in case the ground is wet or
loose. The danger of slipping is very high on cut growth, no
matter if it is wet or dry.
If the mower starts to slide you cannot regain control by actu-
ating the brake.
Uncontrolled sliding can occur because of:
– slope angles that are too steep.
– slippery ground.
– poor tire grip.
– speeding.
– abrupt braking.
– an inappropriate task for the device.
If the device tilts or slips
– Never try to stop a tilting or sliding device. Severe injuries
can result.
– Remove leaking fluids (oil, fuel, battery acid) from the
device and the floor. Deposit of contaminated soil environ-
ment friendly according to the local regulation.
– Undetectable damage may have occurred to the device. In
case of malfunctions, there is a risk of injury. Have an au-
thorised service centre check the device.
Increased risk of tipping with additional
load
When the transport rack is loaded, there is an increased risk
of tipping. Please observe the information on the transport
rack.
Keep in mind that all attachments or additional loads increase
the risk of tilting.
Caution when using accessories
– Only use hitches approved by “AS-Motor Germany”.
– Note the maximum load (see Technical data).
– Observe the safety information in the operator’s manual of
the hitch manufacturer.
– Only transport loads that you can control reliably.
– Only drive on slopes up to max. 10°.
– Do not take tights corners.
– Be cautious when moving in reverse.
When work is completed
After each mowing, close the fuel valve and the tank ventila-
tion.
Before you leave the device, wait for the blade and engine to
stop and pull off the key on the start-stop switch.
After switching it off, let the device cool down for at least
20minutes before you store it in a dry, closed, sufficiently
ventilated room.
Never store the device when there is fuel in the tank inside a
building where fuel vapours might come into contact with
open fire or sparks.
Use caution during maintenance and
repair
Only carry out work as described in these operating instruc-
tions. Have an authorised service centre perform all other
work.
Only use the blades and spare parts authorised by “AS-Motor
Germany”. Unauthorised blades and spare parts can cause
severe injuries.
Prior to all maintenance work, wait until the engine comes to
a standstill and pull off the spark plug connector.
We explicitly point out that, in accordance with the Product
Liability Act, we are not liable for damages that were caused
by our devices if
– worn or damaged parts were not repaired or replaced on
time.
– these damages were caused by improper repair.
– when changing a part, our original parts or parts authorised
by us were not used.
– the repair work was not carried out by an authorised ser-
vice station.
The same applies for spare parts and accessories.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AS Motor AS 940 Sherpa 4 WD RC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AS Motor AS 940 Sherpa 4 WD RC in the language / languages: English as an attachment in your email.

The manual is 2,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AS Motor AS 940 Sherpa 4 WD RC

AS Motor AS 940 Sherpa 4 WD RC User Manual - German - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info